[. . . ] G
RX-N600
AV Receiver Ampli-tuner audio-vidéo
OWNER'S MANUAL MODE D'EMPLOI BEDIENUNGSANLEITUNG BRUKSANVISNING GEBRUIKSAANWIJZING
CAUTION: READ THIS BEFORE OPERATING YOUR UNIT.
CAUTION: READ THIS BEFORE OPERATING YOUR UNIT.
1 2 To assure the finest performance, please read this manual carefully. Install this sound system in a well ventilated, cool, dry, clean place away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. Allow ventilation space of at least 30 cm on the top, 20 cm on the left and right, and 20 cm on the back of this unit. Locate this unit away from other electrical appliances, motors, or transformers to avoid humming sounds. [. . . ] · Select "SINGLE" to set this unit to repeat one song. · Select "ALL" to set this unit to repeat a sequence of songs. Notes
· When "REPEAT" is set to a setting other than "OFF", the highlighted letter "R" appears in the top right corner of the playback status screen while one song or a sequence of songs are being repeated. · If "REPEAT" is set to "SINGLE", the setting will be reset to "OFF" when both the main zone and Zone 2 are turned off.
3 4 5
Note
In case you have changed your network configuration, you may need to reconfigure the network settings again.
Shuffle SHUFFLE Use this feature to set this unit to play songs or albums in a random order. Choices: OFF, ON · Select "OFF" to deactivate this feature. · Select "ON" to set this unit to play songs or albums in a random order. Note ADVANCED OPERATION
When "SHUFFLE" is set to "ON", the highlighted letter "S" appears in the top right corner of the playback status screen while songs or albums are being shuffled.
y
You can reset the network settings of this unit to the initial factory settings by using "N-RESET" in the advanced setup menu (see page 82).
English
77 En
SET MENU
Network information C)INFORMATION
Use this feature to display the network system information.
4 OPTION MENU
Use this menu to adjust the optional system parameters.
C)INFORMATION
MAC ADDRESS XX:XX:XX:XX:XX:XX STATUS 10BASE-T FULL-DUPLEX [ENTER]:Return
4 OPTION MENU
. INI D)MULTI ZONE SET [ ]/[ ]:Up/Down [ENTER]:Enter
p
p
Note
The above display is an example.
Display settings A)DISPLAY SET
MAC (Media Access Control) address MAC ADDRESS This information displays the MAC address that is assigned to this unit. Status STATUS This information displays the current link status of the network. Display status: 10BASE-T, 100BASE-TX, FULL-DUPLEX, HALF-DUPLEX, NO LINK Note
"NO LINK" appears when network connection is not made.
A)DISPLAY SET
. DIMMER;;;;;;;;;0 VIDEO CONV. ;;;ON OSD SHIFT;;;;;;0 GRAY BACK;;;AUTO [ ]/[ ]:Up/Down [<]/[>]:Select
A)DISPLAY SET
. ON SCREEN;;;;10s FL SCROLL;;;CONT [ ]/[ ]:Up/Down [<]/[>]:Select
Dimmer DIMMER Use this feature to adjust the brightness of the front panel display. Control range: 4 to 0 Control step: 1 · Press j to make the front panel display dimmer. Use this feature to set whether to convert the video signals input at the VIDEO and S VIDEO jacks. Choices: ON, OFF · Select "ON" to convert composite and S-video signals interchangeably and up-convert composite and S-video signals to component video signals. Notes
· The converted video signals are only output at the MONITOR OUT jacks. When recording a video source, you must make the same type of video connections between each component. · When composite video or S-video signals from a VCR are converted to component video signals, the picture quality may suffer depending on your VCR. · You must set "VIDEO CONV. " to "ON" to display the OSD. · Unconventional signals input at the composite video or S-video jacks cannot be converted or may be output abnormally. In such cases, set "VIDEO CONV. " to "OFF".
p
p
p
p
78 En
SET MENU
OSD shift OSD SHIFT Use this feature to adjust the vertical position of the OSD. Control range: 5 (upward) to +5 (downward) Control step: 1 Initial setting: 0 · Press j to raise the position of the OSD. [. . . ] / (20 - 20 , 50 , 8 ) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . (250 ) / . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 110/120/220/230 - 240 , 50/60
· / ( IHF-A)
· ( IHF-A)
/ . . . . . . . . . . . . . . . . . . 150 µV
· (1 /10 )
CD (5, 1 ) / . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]