[. . . ] Power off and remove casing Turn off the power and remove Power plug from your computer. Confirm Jumper Setting Decide which convex part you want to use and adjust the jumper. [. . . ] Notice: Do not install two different brand's CD writing software simultaneously in your computer. Installation FAQ (The FAQ & Manual in disc in more detail. ) Q: Computer won't boot up after installation. Please follow these procedures to get your computer back to work: Turn off and unplug your computer first. The Correct connection is that all pins should be fully covered and the colored stripe and the IDE cable lines up with PIN-1 of each connector. If an IDE cable is connected with CD-ReWriter and other device, check the jumper settings of both devices and make sure the "MA" (master) and "SL" (slave) settings are different from each other. The following steps will assist in getting your drive to work as a CD-ROM: If you cannot find CD-ReWriter in Explorer, restart your computer, or shut it down and then turn it on again. You can test it by pressing the eject button to see if the tray opens and closes. Be careful to turn off and unplug your computer system before checking this item. Check the connection by opening your computer system to see if the IDE connector is inserted and the colored stripe on the side of the IDE cable lines up with PIN-1 of each connector. There is another way to activate IDE ports in Windows 95/98: Click Start | Setting | Control Panel | Device Manager | IDE HDD controller | Properties | Settings tab | Select "enable both IDE channels" to enable the IDE channels. Quick Installation Guide E-2 Q: Error message when double-clicking on the CD-ReWriter icon. After loading a CD disc, you need to wait for a short moment to let the CD-ReWriter read the disc information and be ready for further access. [. . . ] For detailed information on Packet Writing method, it is recommended that users to refer to other publications. For detailed information, please refer to your manual guide in the software disc. E-3 Quick Installation Guide [. . . ]