[. . . ] FOR CAR USE ONLY/NUR FÜR AUTOMOBIL GEBRAUCH/POUR APPLICATION AUTOMOBILE UNIQUEMENT/ PARA USO EN AUTOMÓVILES/SOLO PER L'UTILIZZO IN AUTOMOBILE/ENDAST FÖR BILBRUK
R
RDS MP3/WMA CD Receiver
EN
CDE-9845RB/CDE-9845RR
RDS MP3 CD Receiver
DE
CDE-9843R/CDE-9843RM
FM/MW/LW/RDS CD Receiver
FR
CDE-9841R
· OWNER'S MANUAL Please read before using this equipment. · BEDIENUNGSANLEITUNG Lesen Sie diese Bedienungsanleitung bitte vor Gebrauch des Gerätes. · MODE D'EMPLOI Veuillez lire avant d'utiliser cet appareil. · MANUAL DE OPERACIÓN Léalo antes de utilizar este equipo. [. . . ] Valid characters for folder/file names are letters A-Z (all caps), numbers 0-9, and `_' (underscore). This device also can play back discs in Joliet, Romeo, etc. , and other standards that conform to ISO9660. However, sometimes the file names, folder names, etc. , are not displayed correctly.
Formats supported
This device supports CD-ROM XA, Mixed Mode CD, Enhanced CD (CD-Extra) and Multi-Session. This device cannot correctly play back discs recorded with Track At Once or packet writing.
13-EN
Sound Setting
CDE-9845RX
Rotary encoder (MODE/LOUD) BAND
CDE-9843RX/CDE-9841R: · If the MODE/LOUD is not pressed within 15 seconds after selecting the BASS or TREBLE mode, the unit automatically returns to normal mode. *1 When the subwoofer mode is set to OFF, its level cannot be adjusted.
2
Turn the Rotary encoder (CDE-9845RX) or press 4 and 3 (CDE-9843RX/CDE-9841R) until the desired sound is obtained in each mode.
By setting Defeat ON, previously adjusted settings of BASS and TREBLE will return to the factory defaults.
Setting the Bass Control
g CENTER f. f
You can change the bass frequency emphasis to create your own tonal preference.
1
CDE-9843RX/CDE-9841R
BAND 4
CDE-9845RX: Press CENTER f. to select the Bass Control mode.
BASS TREBLE normal mode BASS
CDE-9843RX/CDE-9841R: Press MODE/LOUD to select the Bass Control mode.
BASS TREBLE SUBW BALANCE FADER DEFEAT VOLUME BASS
2-1
g f MODE/LOUD 3
Setting the bass centre frequency: Press g or f to select the desired bass centre frequency.
60Hz 80Hz 100Hz 120Hz 60Hz
The displayed bass frequency is emphasized.
Adjusting Bass/Treble/Balance (Between Left and Right)/Fader (Between Front and Rear)/ Defeat
2-2
Setting the bass band width (Q-Factor): Press BAND to select the desired bass band width. (Wide)
1
Press Rotary encoder (MODE/LOUD) (CDE9845RX) or MODE/LOUD (CDE-9843RX/CDE9841R) repeatedly to choose the desired mode.
Each press changes the modes as follows:
BASS TREBLE SUBW*1 BALANCE FADER DEFEAT VOLUME BASS Bass Level: -7 ~ +10 Treble Level: -7 ~ +7 Subwoofer : 0 ~ +15 Balance : L15 ~ R15 Fader : R15 ~ F15 Defeat : ON/OFF Volume : 0 ~ 35
Changes the boosted bass band width to wide or narrow. A wide setting will boost a wide range of frequencies above and below the centre frequency. A narrower setting will boost only frequencies near the centre frequency.
2-3*2
Setting the bass level: Turn the Rotary encoder (CDE-9845RX) or press 4 and 3 (CDE-9843RX/CDE-9841R) to select the desired bass level (-7~+10).
You can emphasize or weaken the bass frequency.
· If the Rotary encoder (MODE/LOUD) or MODE/LOUD is not pressed within 5 seconds after selecting the BALANCE, FADER, DEFEAT or SUBWOOFER mode, the unit automatically returns to normal mode. CDE-9845RX: · If the Rotary encoder (MODE/LOUD) is not pressed within 5 seconds after selecting the BASS or TREBLE mode, the unit automatically returns to normal mode.
· If no operation is performed within 15 seconds, the bass control setting will be turned off automatically. · The bass level settings will be individually memorized for each source (FM, MW (LW), CD, etc. ) until the setting is changed. The bass frequency and bass band width settings adjusted for one source are effective for all other sources (FM, MW (LW), CD etc. ). *2 CDE-9845RX: The adjustment can also be made by pressing the Rotary encoder (MODE/LOUD). Refer to "Adjusting Bass/Treble/Balance (Between Left and Right)/Fader (Between Front and Rear)/Defeat" (this page).
14-EN
Setting the Treble Control
You can change the Treble Frequency emphasis to create your own tonal preference.
Turning Loudness On/Off
Loudness introduces a special low- and high-frequency emphasis at low listening levels. This compensates for the ear's decreased sensitivity to bass and treble sound.
1
CDE-9845RX: Press CENTER f. to select the Treble Control mode.
BASS TREBLE normal mode BASS
Press and hold Rotary encoder (MODE/LOUD) (CDE-9845RX) or MODE/LOUD (CDE-9843RX/CDE9841R) for at least 2 seconds to activate or deactivate the loudness mode.
The display shows "LOUD ON" when the loudness mode is activated.
CDE-9843RX/CDE-9841R: Press MODE/LOUD to select the Treble Control mode.
BASS TREBLE SUBW BALANCE FADER DEFEAT VOLUME BASS
2-1
Setting the treble Centre frequency: Press g or f to select the desired treble centre frequency.
7. 5kHz 10. 0kHz 12. 5kHz 15. 0kHz 7. 5kHz
The displayed Treble frequency is emphasized.
2-2*2
Setting the treble level: Turn the Rotary encoder (CDE-9845RX) or press 4 and 3 (CDE-9843RX/CDE-9841R) to select the desired treble level (-7~+7).
You can emphasize the treble frequency.
· If no operation is performed within 15 seconds, the treble control setting will be turned off automatically. · The treble level settings will be individually memorized for each source (FM, MW (LW), CD, etc. ) until the setting is changed. The Treble frequency settings adjusted for one source are effective for all other sources (FM, MW (LW), CD, etc. ). *2 CDE-9845RX: The adjustment can also be made by pressing the Rotary encoder (MODE/LOUD). Refer to "Adjusting Bass/Treble/Balance (Between Left and Right)/Fader (Between Front and Rear)/Defeat" (page 14).
15-EN
Other Functions
CDE-9845RX
-/J Rotary encoder
*1 Displayed during playback of a disc with CD Text. "NO TEXT" will be displayed when the CD contains no Text data. [. . . ] Type de véhicule dans lequel cet appareil est installé:
Marque: Année d'achat: Modèle: Année du modèle:
Q6. Tipo de vehiculo en que la unidad está instalada:
Marca: Año de compra: Modelo: Año del modelo:
Q7. Remplacement · Marque précédente remplacée?Sustitución · ¿Sustitución de marca anterior? [. . . ]