[. . . ] Surge protectors are built-in to the power supply and protect the cameras. The power supply must be plugged directly into your wall outlet.
Add-On Camera
1 Logitech Alert Camera 2 Camera power supply 3 Power supply cable (yellow tips) 4 Mounting accessories 5 microSDTM card adapter
6 Suction cup 7 Desktop stand 8 Power supply cable extender 9 System Requirements Guide
1 Run Logitech Alert Commander
Before you begin the installation, read all instructions.
2 Plug in Your Camera
When prompted to connect your camera: 1) Remove the hatch from the back of the camera. [. . . ] 2a) Plug the power supply into an outlet near the PC where the software is installed.
3 Choose Your Camera Location
On a desk or table
!
Logitech Alert Master System required.
1
1a
1b
2
2a
1) Be sure that Logitech Alert Commander sotware is running on the PC before beginning installation of camera. · Shortly after connecting, your camera will appear in Alert Commander software. You can now move the camera to its desired location.
On a window looking out or in
Using In-the-box Accessories
Wall/Ceiling Mounting Instructions
The wall mount allows you to easily fasten your camera to a ceiling or wall. 1) Start by pre-drilling holes into the wall and screwing in the mounting base. 3) Attach the camera to the mounting arm.
1
3
OR
2
OR
Clean the window's surface and the inside area of the suction cup before applying it to the window. See F1 Help for instructions.
* See Camera Reset Instructions for assistance.
Using the microSDTM card adapter
LED OFF ON
NOTE: Unplug the camera before removing, replacing, or upgrading your microSD card. To review the video on the microSD card, we recommend using Logitech Alert Commander.
On/Off switch for Power Supply LEDs
To review the video on the microSD card without Logitech Alert Commander: 1) Open the hatch on the bottom of the camera and remove the microSD card from its port. · View video recordings using the free Apple QuickTime player or other player that supports H. 264 video playback. (To download QuickTime, visit http://www. apple. com/quicktime/download/) www. logitech. com
1
2
3
How do I turn these LEDs off?
Use the switch located on the side of the power supply to disable these diagnostic LEDs.
SMA
COM
RTM
EDIA
H I/II MMC/ MS/M
PAC TF
LAS
SD
S PRO
© 2010 Logitech. Logitech, the Logitech logo, and other Logitech marks are owned by Logitech and may be registered. [. . . ] (To download QuickTime, visit http://www. apple. com/quicktime/download/) www. logitech. com
1
2
3
How do I turn these LEDs off?
Use the switch located on the side of the power supply to disable these diagnostic LEDs.
SMA
COM
RTM
EDIA
H I/II MMC/ MS/M
PAC TF
LAS
SD
S PRO
© 2010 Logitech. Logitech, the Logitech logo, and other Logitech marks are owned by Logitech and may be registered. [. . . ]