[. . . ] Detect the cause and solve the problem, then replace the fuse with another one of the same size and rating. To prevent malfunction of the amplifier and speakers, the protective circuit will cut the power supply to the amplifier (sound will stop) when an abnormal condition occurs. In such a case, switch the power to the system OFF and check the connection of the power supply and speakers. [. . . ] This unit is for vehicles with a 12-volt battery and negative grounding. If the car stereo is kept on for a long time while the engine is at rest or idling, the battery may go dead. If the system remote control wire of the amplifier is connected to the power terminal through the ignition switch (12 V DC), the amplifier will always be on when the ignition is on-- regardless of whether the car stereo is on or off. Because of this, the battery could go dead if the engine is at rest or idle. Speakers to be connected to the amplifier should conform with the standards listed below. If they do not conform, they may catch fire, emit smoke or become damaged. But in case of two-channel and other bridge connections, the speaker impedance must be 2 to 8 ohms. Install and route the separately sold battery wire as far away as possible from the speaker wires. Install and route the separately sold battery wire, ground wire, speaker wires and the amplifier as far away as possible from the antenna, antenna cable and tuner. Cords for this product and those for other products may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function. Car stereo with RCA output jacks External Output For details on how to connect to RCA input jacks A and B, see the "Connecting the Speakers and Input wires" section. Subwoofer Other than subwoofer Subwoofer Other than subwoofer Subwoofer Other than subwoofer Subwoofer Other than subwoofer Ground wire Lug System remote control wire (sold separately) Connect the male terminal of this wire to the system remote control terminal of the car stereo (SYSTEM REMOTE CONTROL). The female terminal can be connected to the auto-antenna relay control terminal. If the car stereo does not have a system remote control terminal, connect the male terminal to the power terminal through the ignition switch. Connect the speaker leads to suit the mode according to the figures shown below. [. . . ] To ensure proper heat dissipation of the amplifier, be sure of the following during installation. Do not install the amplifier on unstable places such as the spare tire board. The best location for installation differs with the car model and installation location. [. . . ]