[. . . ] 1 Read instructions - All the safety and operating instructions should be read before the product is operated. 2 Retain instructions - The safety and operating instructions should be retained for future reference. 3 Heed Warnings - All warnings on the product and in the operating instructions should be adhered to. FRANÇAIS DEUTSCH NEDERLANDS ESPAÑOL ITALIANO PORTUGUÊS SVENSKA 2 4 Follow Instructions - All operating and use instructions should be followed. [. . . ] For example, a CD-player with balanced outputs would connect to the balanced input. Rename the balanced input to CD-Player as follows; Press and hold simultaneously the listen and record / Z2 buttons until the cursor flashes. Rotate the volume (set up) control to the letter "C" then press the listen button to lock the selection and advance the cursor. The variables are; lowercase letters, uppercase letters, numbers, and miscellaneous punctuation symbols. Record each name you assign into the chart on page 17 to aid you for future reference in the event you wish to change the hook-up and assignment of the inputs. Record / Z2 (second zone output): Press the record / Z2 button to select the input as the recording source. A press longer than one second will advance the source selection to the next input as follows; OFF, DISC, CD, TUNER, INPUT 4, INPUT 5, INPUT 6, BALANCED, LOCAL, and then return to OFF. furthermore , the ZR3 remote control will allow direct selection of inputs (see ZR3 Remote Control). The record / Z2 will maintain its last state even if the M3 is set to standby. Setting the mode to Left or Right allows one to easily balance left signal inputs with right signal inputs. A press longer than one second will advance the mode selection to the next state as follows; STEREO, MONO, LEFT, RIGHT, and then return to the STEREO listening mode. 5 dB To adjust balance; press the balance button once and then within 5 seconds, rotate the volume (set up) control to adjust the either the LEFT or RIGHT balance level. After about 5 seconds, the balance menu will switch off saving the balance settings in memory. A press longer than one second will toggle the tone option between TONE ACTIVE and TONE DEFEAT. Then press the tone button to toggle through bass, treble and tilt functions. selecting TONE ACTIVE allows one to adjust the bass , treble , and spectral tilt settings of the M3 via the volume (set up) control. the spectral tilt adjustment allows for simultaneous +/-3dB bass and treble offsets. When adjusting bass and treble levels, the spectral tilt value will remain 0dB. When adjusting the spectral tilt, the bass and treble values will follow the spectral tilt adjustment simultaneously. press the speakers button to toggle through the four speaker selections. A press longer than one second will advance the speaker selection as follows; SPEAKERS A, SPEAKERS B, SPEAKERS A+B, SPEAKERS Off, and then return to the SPEAKER A selection. The turn on volume level will always revert to -20 dB if the volume level is set to greater than -19 dB before switching to standby. [. . . ] A press longer than one second will advance the crossover frequency selection as follows; BIAMP CROSSOVER FULL RANGE, HIGH PASS 40 Hz, HIGH PASS 60 Hz, HIGH PASS 80 Hz, HIGH PASS 100 Hz, and then return to FULL RANGE. Using a paper clip, select either position 1 or 2 taking care not to damage the switch with excessive force. The TITLE button will become a Repeat function button, the MENU button will become a Random function button, and the DISP button will become a Time function button. ON/OFF: The M3 must be in its on-state in order to use the ZR3 remote control. [. . . ]