[. . . ] CE - Certificate This equipment is in compliance with the requirements of the following regulations: EN 55 022: CLASS B FCC Conditions This equipment has been tested and found to comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference (2) This device must accept any interference received. [. . . ] Do NOT connect the docking station to your computer before installing the software from the provided CD. If you accidentally plug in the docking station first, a couple of New Hardware Found Wizard screens will pop up. Before you connect the docking station to your computer for the first time, please run the setup program as follows: When the welcome screen appears, click Next. Plug the square end (Type B male receptacle) of the USB cable into the USB upstream connector located on the side of docking station. Plug the flat end (Type A male receptacle) of the USB cable into a free USB port on your computer. (Optional) Plug the power adapter to a household AC outlet and plug the adapter's DC jack into the DC socket on the side of docking station. Once you finish the installation, you can open the Windows Device Manager (via My Computer > Properties > Hardware) to verify that your docking station is properly installed with all the provided functions. The self-power mode means the peripheral has its own power adapter for operation. Bus-power mode means the peripheral operates under the power from the upstream port that it is connected to. 0 docking station can operate under both USB bus-power and self-power mode. [. . . ] thus , the compatibility of the USB-to-serial interface and the serial mouse is not guaranteed at all. There are a few rare cases where it can work, but the majority of the serial mice is not compatible with the USB-toserial interface. [. . . ]