[. . . ] Press [ ] or [ ] to set the number of flats (the number of flat semitones) you want. The sound of the note name/string number shown in the display is played. CHROMATIC mode: You can play any of the twelve notes in the chromatic scale (C4­B4). When you're using the Flat feature, the pitch of the tones played is adjusted accordingly. [. . . ] When you're using the Flat feature, the pitch of the tones played is adjusted accordingly. (Sound button) This switches the reference tone's sound or metronome sound on and off. SEL Each press of this button switches among functions in the sequence described below. tuner mode: Tuning mode - Flat feature Reference Pitch Metronome mode: Rhythm Style - Beat - Tempo (Down)/ (Up) These change various settings. TAP Set the metronome's tempo by tapping this button in time with the beat. Speaker This plays the metronome sound, the reference tone, and the AccuPitch sound. Sounds arriving at the INPUT jack, MIX IN jack, and the built-in mic are not played through the speaker. When you're using Sound mode, tuning cannot be performed using the built-in mic (the built-in mic is disabled). When using battery power, if the RPS-10 remains in the state described below for approximately thirty minutes after it was turned on, the power will automatically be switched off. You can temporarily deactivate the Auto Power Off feature when you power up the RPS-10. Rhythm Style Number This indicates the rhythm style number (the way the metronome sound) that you choose. If the battery is removed or is depleted, all data saved in memory may be lost. * When turning the unit upside-down, place it on a soft cloth or the like so as to prevent damage to the panel. If you're tuning an acoustic instrument, use the built-in mic instead. To use the mic, make sure that nothing is connected to the INPUT or OUTPUT jacks, and place the RPS-10 near the instrument. * To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections. Open the battery compartment (located on the bottom of the unit) by sliding the cover toward OPEN. * Make sure the "+" and "-" terminals of the battery are oriented correctly. Press [SEL], then press [ ] [ ] to choose the tuning mode (CHROMATIC, GUITAR, or BASS). If necessary, press [SEL] with [ ] and [ ] to make settings for Flat tuning and/or the reference pitch. [. . . ] Press [SEL], then press [ ] [ ] to choose the tuning mode (CHROMATIC, GUITAR, or BASS). If necessary, press [SEL] with [ ] and [ ] to make settings for Flat tuning and/or the reference pitch. When the setting has been made, press [SEL] a number of times until the flashing display ends. 0Hz) Expected battery Approximately 8 hours life under contin- This figure will vary depending on the uous use (carbon) actual conditions of use. [. . . ]