[. . . ] The software must be installed on a personal computer, running Windows® XP or Windows® Vista. Your machine must be registered using 4DTM Configure on the computer with the machine connected. [. . . ] Internet updates for the machine can only be received via the Smart Update feature in 4DTM Configure. If you need assistance registering your machine, full instructions are found in the Internet FAQs. Enter "HC020" in the Search box and choose "all FAQ" for the Search. TM port as when you activated the Embroidery Machine Communication at installation. Open the program 4DTM Configure (Go to Start/All Programs/4D Embroidery System/4D Configure). The program starts searching for the latest update version for your machine and a list with suggested downloads is presented. Since it is highly recommended to "restore the machine to default factory embroidery disk" in order to get full access to all new features, the user should save all personal files and embroideries before performing the update as described below. Connect your creative visionTM sewing and embroidery machine to the computer with the USB Cable. Select advanced options and select restore to default factory embroidery disk. This is important for performance reasons and in order to get full access to all new features (cut jump stitches). b. To start updating, hold the stitch restart and needle down button, on the front of your machine, simultaneously as switching the machine on. When the first part of the boot update is completed, press OK to confirm that the sewing machine has restarted in boot update b. Close the files were saved to your embroidery stick prior update window. Select Files and Folders in the selection bar at the bottom of the screen 4. Use the Folder Structure Arrow Down next to Personal Files and select USB Embroidery Stick. [. . . ] Use the Folder Structure Arrow Down next to Personal Files and select USB Embroidery Stick. You will see the progress of your update on your computer screen as well as on your machine. [. . . ]