[. . . ] To prevent fire or electric shock, do not expose the speakers to dripping or splashing. · To prevent the enclosure from warping or discoloring, do not place the speakers where they will be exposed to direct sunlight or excessive humidity. [. . . ] Do not mount them on thin plywood or soft wall surface material, as the screws may come out of the flimsy surface, causing the speakers to fall down and be damaged, or result in personal injury. · Do not fasten the speakers to wall with nails, adhesives, or other unsound hardware. · To avoid accidents resulting from tripping over loose speaker cords, fix them to the wall. Note: You can also use the screw holes on the bottom of the NS-M125 for installing the speakers on commercially available speaker stands.
A screw with a diameter of 6 mm (1/4") can be used (Hole depth: 20 mm, 3/4") 60 mm (2-3/8")
· Before installing, please refer to the instruction manual of the speaker stand.
E-3
Placing the center speaker NS-C125
Place the speaker on the floor under the TV or inside the TV rack so that it is stabilized.
Mounting the center speaker NS-C125 on the wall
The speaker can be mounted on a wall by using the bracket attached to the speaker's back panel.
Holes
Make sure that the screws are caught by a narrow part of the holes securely. When placing the speaker on top of the TV To prevent the speaker from falling down, put the provided fasteners at two points on both bottom of the speaker and top of the TV.
NS-C125 Peel off the seal 292 mm (11-1/2")
Fasten screws into a firm wall or wall support as shown in the figure below, and hang the holes on the protruding screws.
NS-C125
1
Fastener TV set
2
Diam. 20 mm (3/4") Wall or wall support 3 mm (1/8") Tapping screw (commercially available)
Notes: · Do not place the speaker on top of the TV whose area is smaller than the bottom area of the speaker. · Do not place the speaker on top of the TV with an inclination. · Do not touch the adhesive surface after peeling off the seal as this will weaken its adhesive strength. · Thoroughly wipe clean the surface where the fastener is to be applied. Note that adhesive strength is weakened if the surface is dirty, oily or wet and that this may cause the center speaker to drop.
WARNING: · The speaker weights 2 kg (4. 4 lbs). Do not mount them on thin plywood or soft wall surface material, as the screws may come out of the flimsy surface, causing the speakers to fall down and be damaged, or result in personal injury. · Do not fasten the speakers to wall with nails, adhesives, or other unsound hardware. · To avoid accidents resulting from tripping over loose speaker cords, fix them to the wall.
E-4
Connecting Your Speakers
Always turn off your amplifier or receiver before making any connections.
English
Preparing Your Speaker Cables
Carefully remove 10 mm (3/8 ")of insulation from both ends of your speaker cables and twist the bare wires tightly, as shown.
10 mm (3/8 ")
Good
No Good
Hookup
NS-C125
CENTER
R
FRONT OR SURROUND
L
Amplifier or receiver
+
Tighten Loosen
+
NS-M125
Notes: · Make sure that the bare wires are not touching each other as this could damage the speaker and amplifier. · Connect one speaker to the left terminals of your amplifier, and another speaker to the right terminals, making sure not to reverse the polarity (+, ). [. . . ] RUE AMBROISE CROIZAT BP70 CROISSY-BEAUBOURG 77312 MARNE-LA-VALLEE CEDEX02, FRANCE ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD18 7GQ, ENGLAND SCANDINAVIA A. B. [. . . ]