[. . . ] Press the [Clear] key to program another feature or exit the program mode by turning the PRG key to the OFF position. Type/Press: [1530] + [Qty/Date] NOTE: If you wish that the time just entered be printed and displayed in the 24-hour format, type [180] and then press the [Void] key. Type [19] followed by [1] and [Void] to print in Spanish, [19] followed by [2] and [Void] to print in French, [19] followed by [3] and [Void] to print in German. [. . . ] Type [28] to indicate the machine condition to be changed (Euro convert function allowed/not allowed) and then type [1] to disable the Euro convert function. The message "TAX n RATE" appears on the operator display where n is the number representing the VAT rate. Up to five digits can be used, and you MUST enter three digits after the desired decimal place. The tax rate entered followed by its alphanumeric identifier (T1, T2, T3 or T4) is printed. Press the [Clear] key to program another feature or exit the program mode by turning the PRG key to the OFF position. This format can be changed, as needed, to one of the other settings below. Type the status number [0, 1, 2 or 3] to select the desired format as indicated in the following table: Status Number 0 1 2 3 Format x x. The setting made is automatically printed along with the caption "R-A-". Press the [Clear] key to program another feature or exit the program mode by turning the PRG key to the OFF position. Example: Program the cash register so that two digits are left after the decimal point. The message "PLU PRICE" appears on the operator display and the number 001 is displayed on the left-hand side of the displays to indicate the first PLU number. If you wish to change the PLU number from 001 to another number such as 30, type [030] and then press the [PLU] key. Press the appropriate [Department] key to assign the PLU to a Department from 1 to 20. The message "PLU NAME" is displayed while the PLU number, item price and department number are printed. [. . . ] The symbol "C" is displayed on the left-hand side of the operator and customer displays while the message "CLERK PASS" is displayed on the operator display. Repeat the above operations (from step 4 to step 6) to assign a secret code to the remaining 14 Clerks or use the [Clear] key to exit from Clerk Secret Code programming. If you wish to change the clerk's secret code and the Clerk system is already activated, there is no need to perform step 2 above. [. . . ]