[. . . ] Keep the machine and the electrical cord out of children's reach. The cord or any other defective element must be replaced exclusively by an authorized after-sales service centre. Equally included are 4 varieties of Nespresso coffee (4 x 10 capsules) allowing you to use the machine immediately. For further information concerning the different varieties of Nespresso coffee and to order capsules, contact your Nespresso Club at the address found on your machine or in the «Welcome-pack». [. . . ] Once the desired quantity of water is obtained, return the function knob to the «0» position. First prepare a Nespresso in a cappuccino cup filling it only one-third full. Remove the capsule holder from the spout ring, discard the used capsule and reinsert the empty capsule holder in the spout ring. Once the yellow temperature control light goes off, the machine is ready for use. Plunge the steam nozzle into the receptacle and turn the function knob to the position on the left (17). Maintain the end of the nozzle under the surface of the milk during the entire procedure ensuring that it does not touch the base of the receptacle. stop the steam by turning the function knob to the «0» position. Once the yellow temperature control light goes off, your machine is warmed up and ready for use. Remove the capsule holder from the spout ring and insert a capsule with the largest part towards the base (11). Reinsert the capsule holder in the spout ring by turning it from left to right without tightening with great force (12). The steam nozzle is useful in making frothed milk for a cappuccino, or for heating a liquid. Once your Nespresso is prepared, return the function knob to the «0» position. Remove the capsule holder from the spout ring and discard the used capsule (14). Pour approximately 1 dl of cold whole milk into a sufficiently high pot (of not more than 0. Turn the function knob again to the position on the left for just a second in order to eliminate any residual milk that otherwise can block the steam nozzle. Wipe the steam / hot water nozzle with a clean damp cloth immediately after its use. Before reinserting the drip tray and grill, ensure that the back cover of the drip tray is properly in place (20). Either run hot tap water through it or simply insert the empty capsule holder in the spout ring and let water run through it while slightly loosening and re-tightening the capsuleholder to vary the pressure flow. For optimal cleaning of your capsule holder, a specially conceived cleaning product is also available from your Nespresso Club. Clean the steam / hot water nozzle with a clean, damp cloth after each use. If the nozzle is blocked, unscrew it with the aid of a coin and remove the residue causing the blockage with a needle. Take this occasion to remove the integrated frothing attachment from the bottom part of the steam nozzle by unscrewing it with the help of a coin if necessary. [. . . ] To do this, insert the empty capsule holder into the spout ring, place a receptacle under the coffee spout and run the equivalent of one or two large cups of water by turning the function knob to the position on the right. Once the yellow temperature control light goes off, the machine is ready for use. Important: To extract a Nespresso after having used the steam, let the machine cool down. To do this, insert the empty capsule holder in the spout ring, place a receptacle under the coffee spout and run the equivalent of one or two large cups of water by turning the function knob to the position on the right. [. . . ]