[. . . ] &
This option connects a GL3000 or GL3300 console as a channel expander to a second console with just one or two interconnecting cables.
Kit Part No:
GL3000-SL1
Single option to install SYS-LINK to one GL3000 console to allow interconnection to a second console already fitted with SYS-LINK.
Kit Part No:
GL3300-SL1
Single option to install SYS-LINK to one GL3300 console to allow interconnection to a second console already fitted with SYS-LINK. For information on using SYS-LINK please refer to APPLICATIONS NOTE AP2565
FITTING INSTRUCTIONS
Publication AP2564
Issue 2 Dec 97
FITTING THE SYS-LINK EXPANDER OPTION OE
CHECK THE CONTENTS :
Please check carefully the SYS-LINK circuit board assembly is the correct one for the console in which it is to be installed.
D type connector fixings already fitted. [. . . ] 4, prepare the solder pads on the circuit boards with new solder to ease the soldering of the SYS-LINK wires. Note, the wires are soldered to the trackside of the circuit boards and not the component side. It is recommended that the wires in the SYS-LINK harness are soldered to each circuit board in the following order: GROUP 4 then GROUP 3 then GROUP 2 then GROUP 1 then LEFT and then finally the RIGHT PCB.
4
GL3000 & GL3300 SYS-LINK OPTION
ALLEN & HEATH
11
MOUNTING THE SYS-LINK CIRCUIT BOARD:
The SYS-LINK circuit board mounts onto the GROUP 1 circuit board using the 3 pillars already fitted to the SYS-LINK circuit board assembly. On the GL3000 GROUP circuit board, one mounting hole requires drilling. 5
To fit the SYS-LINK circuit board to the GROUP circuit board, unscrew the 3 screws already partly screwed into the mounting pillars and align with the holes in the GROUP circuit board. 6, slide the SYS-LINK harness toward the back of the console and down the gap between the CONNECTOR circuit board and the GROUP circuit boards. 2, fit the GROUP and SYS-LINK circuit board assembly and re-connect the flexible flat cables (D) to the GROUP and LEFT circuit boards.
12
FITTING THE SYS-LINK HARNESSES :
Refering to fig. 6 below, fit the 4 SYS-LINK ribbon harnesses to the connectors on the edge of the SYS-LINK circuit board. Note which connector each harness plugs onto and the correct alignment of pin 1 with the red stripe on the ribbon cable. Remove the D type mounting screws from the D type connectors and mount them onto the rear panel using the fixings supplied. [. . . ] The SYS-LINK Applications Note AP2665 is included separately with these fitting instructions. Please refer any queries to your Allen & Heath appointed service agent.
ALLEN & HEATH
GL3000 & GL3300 SYS-LINK OPTION
7 [. . . ]