[. . . ] â· Ensure that the person using the stroller knows how to use it safely. â· WARNING: when opening or closing the stroller, ensure that your child is at a safe distance. Ensure that during these operations, the movable parts of the stroller do not come into contact with your child. WARNING: never leave the stroller on a sloped surface with a child on board, even with the brakes applied. [. . . ] To fit the fabric cover to the stroller, carry out the following operations. Fix the fabric cover to the seat, fastening the press studs as shown in diagram 15A-15B. To fit the backrest, first fix the rear joint (F), turning it until the two locking pins located on the frame coincide with the holes located on the joint (diag. After inserting the locking pins into the holes, push the joint, until a click is heard, indicating that the locking pins are correctly locked into position (G), as shown in diagram 5. Fix the front joint (C), pushing it into its appropriate housing (D), exercising a slight pressure on the tube of the backrest, as shown in diagram 6, until a click is heard, indicating that it is correctly locked into position. WARNING: Ensure that, after carrying out the assembly operations, the adjustment levers of the backrest (B) are located under the adjustment racks (diag. If they are not positioned as shown in diagram 7 B), release the front joints of the backrest (point 8 of the instructions) and reassemble them (following the instructions indicated in point 6), making sure to position correctly the levers under the racks. Fit the fabric cover on the seat, following, in the reverse order, the strollers' instructions indicated in the paragraph "HOW TO REMOVE THE FABRIC COVER". WARNING: Before using the product in the stroller version, always check that the backrest is fitted into the correct position. This stroller has a 5-point safety harness that features two shoulder straps, a waist strap and a crotch strap with buckle. WARNING: When using the safety harness with children from birth up to approximately 6 months of age, it is necessary to first fit the shoulder straps through the two adjustment holes on the fabric backrest. 18 A) and check that the shoulder straps are adjusted at the correct height for your child. After sitting the child in the stroller, insert the 2 prongs into the buckle and, if necessary, adjust the width of the waist belt operating the buckles (diag. To ensure maximum safety, the stroller has "D" rings to allow you to fasten an additional safety harness approved to BS 6684 regulation. The rings are located inside the stroller's seat, on the right and left side, as shown in diagram 20. WARNING: To ensure your child's safety, it is necessary to always use the safety harness. WARNING: the use of the crotch strap and safety harness is necessary to guarantee the safety of your child. WARNING: The child's weight can make these operations more difficult. Remove the seat's fabric cover, following the instructions of the stroller, indicated in the paragraph "HOW TO REMOVE THE FABRIC COVER". First release the front joint, by pressing the release button located on the side (E) and pulling the tube of the backrest in an upward direction (diag. Now release the rear joint, pressing the locking pin (G) and, at the same time, pulling the joint inside (diag. Open only one side of the bumper bar to place the child into the stroller more easily. [. . . ] To mount the basket on the stroller, thread the tape fasteners around the back legs of the stroller, above the seat tube (diagram 39A). Then thread the other tape fasteners around the front legs and press the buttons (see diagram 39 B). The CHICCO strollers featuring the CLIK CLAK system on the armrests allow you to fit the carrycot and/or child car seat to the frame of the stroller without using any additional devices. To fit or remove the carrycot or child car seat, please refer to the specific instructions supplied. [. . . ]