[. . . ] 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Fastening bolt for rebating depth stop * Rebating depth stop* Chip ejector (alternatively right/left) Depth adjustment knob Planing depth scale Chip ejection selector lever On/Off switch Lock-off button Belt cover Screw for belt cover (2 x) Planer base plate V-grooves Parallel guide* Fastening bolt for parallel and beveling guide Working safely with this machine is possible only when the operating and safety information are read completely and the instructions contained therein are strictly followed. In addition, the general safety notes in the enclosed booklet must be observed. S If the mains cable is damaged or cut through while working, do not touch the cable but immediately pull the mains plug. [. . . ] When using other vacuum hose systems a suitable extraction adapter may be required. When vacuuming dry dust that is especially detrimental to health or carcinogenic, use a special vacuum cleaner. Set the required planing depth and place the front part of the planer base plate 11 against the workpiece. Switch the machine on and guide the machine with an even feed over the surface to be planed. To achieve high-grade surfaces, work only with low feed and apply pressure on the centre of the planer base plate. Hardwood) as well as when utilising the maximum planer width, set only low planing depths and reduce planer feed, as required. Excessive feed reduces the surface quality and can lead to rapid clogging of the chip ejector. Only sharp blades achieve good cutting capacity and give the machine longer life. The chip ejector 3 can be switched to the right or left with the selector lever 6. The V-grooves 12 in the front planer base plate 11 allow quick and easy beveling of workpiece edges. For this, place the planer with the V-groove 12 onto the edge of the workpiece and guide along the edge. The blade protector 21 allows the machine to be set down directly after operation, without danger of damaging the working surface or the planer blade. Using the Parallel/Beveling Guide (Accessory see figure D ) Mount parallel guide 13 or beveling guide 17 to the machine using fastening bolt 14 and rebating depth stop 2 using fastening bolt 1. Carry out the planing procedure several times, until the required rebating depth is reached. Pay attention that the planer is guided with sideward supporting pressure. Before assembling a new drive belt, clean both belt pulleys 27 and 29. [. . . ] Live = brown neutral = blue Do not connect the blue or brown wire to the earth terminal of the plug. Important: If for any reason the moulded plug is removed from the cable of this machine, it must be disposed of safely. Recycle raw materials instead of disposing as waste The machine, accessories and packaging should be sorted for environmental-friendly recycling. [. . . ]