[. . . ] SETTING THE CLOCK
Press the ON/STAND-BY button to enter the stand-by mode. [. . . ] q When the 12-hour display is selected, "AM" will change automatically to "PM". or ) button to adjust the
5 6
3
RESETTING THE MICROCOMPUTER
4 7 8 1
q Press the button for at least 0. 5 seconds to change the time in 5-minute intervals. q The hour setting will not advance even if minutes advance from "59" to "00".
0:00
AM 12:00
AM 0:00
Reset the microcomputer under the following conditions:
5 9
Press the MEMORY/SET button. (Seconds are not displayed. )
q To erase all of the stored memory contents (clock and timer settings, and tuner and CD presets). q If the operation is not correct.
OPERATION MANUAL
6
6 2
2
Note: q To erase the tuner preset memory, see "To erase all of the contents of preset memory" on page 18. While pressing down the VOLUME button and the TUNING/TIME button, hold down the ON/STAND-BY button for at least 1 second.
7
Note: q In the event of a power failure or when the AC power lead is disconnected, the clock display will go out. [. . . ] Caution: q The operation explained above will erase all data stored in memory including clock and timer settings, and tuner and CD presets.
When the unit is on: x Press the CLOCK button. [. . . ]