[. . . ] (1)This stand is meant for use with the specified speaker systems. Please do not use stand for other functions. [. . . ] Attention If the leg pins are properly threaded but are still hard to turn, use the small hard to turn, use the small Allen wrench to turn them. Leg Pin Locking Nuts× Small Allen Wrench× Large Allen Wrench× Flush Head Allen Screw×4 Leg Pin Locking Nuts×5 Leg Pin×5 Leg Pin Plate×5 Flush Head Allen Screw× Leg Pin× Leg Pin Plate× Place the top plate on the standing support columns. Use the large Allen wrench to attach the 4 flush head Allen screws, lightly fastening the top plate to the columns. Do not completely tighten the screws at this time. After the leg pins have been attached, set the stand upright and place it in the location desired for use. Attention When setting up or moving the stand, be careful that the leg pins do not scratch your floor. Using the small Allen wrench, turn the leg pin down so that it becomes flush. Attention If the locking nut is hard to turn, use the open end wrench provided. Align the base of the speaker with the top plate of the stand and set it in place. After the top plate is attached to the support columns, turn the assembly upside down. Use the same procedure explained in (1)- above, then use the large Allen wrench to lightly fasten the base plate to the support columns with the screws. [. . . ] Attention Be sure the Allen wrench is pushed all the way into the screw's socket before tightening. After Base Plate Weight Height(mm) L×Wmm) (kg) 350×325 720 28 Specifications and external appearance may change without notice. [. . . ]