[. . . ] [. . . ] Adjust the thickness of the rubber padding to match the actual thickness of the handlebar then tighten screws to install the bicycle mount firmly. When it click into place, tighten the screw on the back of the holder. (5) To remove the GPS, loosen the screw on the back of the holder, press lightly on the pressure tab protruding from the bottom of the holder then remove GPS. (1) (2) (3) (4) (5) 4. Status Bar and Icons Satellite Info Icon / Description Satellite info Strong signal/no signal Cold start Time Icon Description Time information including clock, date and day of the week Charge Info Icon Description Charge full Battery low, 1/3 remaining Battery low Compass Icon Description Alarm setup shortcut; indicates alarm is on Indicates alarm is off Memory Card Icon Description Tracks and waypoints are stored in SD card Tracks and waypoints stored in internal memory Alarm Icon Description Compass is calibrated Compass requires calibration Backlight Icon Description Indicates alarm is on Indicates alarm is off Screen Lock Icon Description Backlight is on Backlight is off Track Log Icon Description Screen is locked Screen is not locked Recording track Track recording paused Basic Button Functions Icon Description Create new file Display 3 Trip Computer pages Pause (used by Alarm and Track Log) Trip Computer setup Confirm Icon Description Back Display 6 Trip Computer pages Start (used by Alarm and Track Log) Next Page Previous Page Note: Please use the bundled USB cable to connect the device to the PC/Notebook and access stored data. [. . . ] [. . . ]