[. . . ] Insert the 3. 5mm audio jack on the Earbuds into the 3. 5mm stereo headphone jack on the iPod nano or any portable audio device. Insert iPod nano (screen end first) into the nano Sock allowing access to the 3. 5mm stereo headphone jack of the iPod nano. [. . . ] Using the white and red label tab, peel the back mask off of the Protective Screen Film. Place the Protective Screen Film (low adhesive side down) on the screen of the iPod nano. The edges of the Protective Screen Film should be flush with the screen of the iPod nano. To remove dust and finger prints and prevent grime from building up, simply wipe the screen of the iPod nano thoroughly with the Cleaning Cloth until the screen is clean. Insert the Dust Cover into the 30-pin connector port of the iPod nano anytime the 30-pin connector is not in use. 11 in 1 Accessory Kit for 5th generation iPod nano Everything You Need for Your 5th generation 3. Volume level can be adjusted using the volume control on the iPod nano or portable audio device. Check that the Crystal Case is separated into two panels (front and back) before installing the iPod nano. The front panel has a window for the iPod nano screen as well as a window for the click wheel. Place the iPod nano onto the back panel so that the screen and click wheel on the iPod nano are facing up. Place the front panel of the Crystal Case onto iPod nano and align the two so that the circular window on the front panel of the Crystal Case aligns with the click wheel on the iPod nano. The 2 panels of Crystal Case and the iPod nano should be flush on all sides. Pinch all 4 corners of the Crystal Case until it is snapped closed securely around the iPod nano. [. . . ] Connect up to 2 sets of earbuds or headphones to the 3. 5mm audio inputs available on the Audio Splitter. Insert iPod nano (screen end first) into the Mesh nano Sleeve allowing access to the 3. 5mm stereo headphone jack of the iPod nano. www. isound. net FOR TECHNICAL SUPPORT PLEASE CONTACT: 1-877-999-DREAM or support@dreamgear. net [. . . ]