[. . . ] This product meets the requirements of the current European and national guidelines. conformity has been established and the relevant statements and documents have been deposited by the manufacturer. OC-1 is a special matrix controller developed to control the LED OCTOPANEL very easily: no need for time consuming DMX-programming, just plug and play!Different working modes: Fixed color mode: Instant access to 9 pre-programmed colors Static chase mode: 32 different matrix color chases with manual speed control Sound chase mode: 32 different matrix color chases with audio triggering Spectrum mix: 32 different spectrum mix colors, including color fades Adjustable speed and dimming with fader Full automatic DMX-address function for up to 16 LED OCTOPANELunits! [. . . ] Don't cover any ventilation openings as this may result in overheating. Always unplug the unit when it is not used for a longer time or before you start servicing. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Check that the available voltage is not higher than the one stated on the rear panel of the unit. The socket inlet shall remain operable for disconnection from the mains. The power cord should always be in perfect condition: switch the unit immediately off when the power cord is squashed or damaged. It must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard Never let the power-cord come into contact with other cables!In order to avoid a hazard, the unit shall only be used with the AC-adaptor delivered with it. Always replace a damaged fuse with a fuse of the same type and electrical specifications!In the event of serious operating problems, stop using the appliance and contact your dealer immediately. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Do not use volatile liquids such as benzene or thinner which will damage the unit. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. This symbol means: indoor use only COLOR/CHASE BUTTONS: These buttons have different functions, depending on the selected working mode (refer to n°2): FIXED COLOR MODE: You can select 9 different predefined colors. MATRIX CHASE: together with the chase/color fader (3) you can select 32 different chases (sound activated or not) AUTO ADDRESS MODE: with the buttons "red" and "orange" you can automatically assign the DMX addresses for two different 8x8 matrixes. MODE SELECT BUTTONS: 3 buttons used to set the controller in different working modes: FIXED COLORS: select this mode if you want to use the "fixed color" buttons (1). CHASE MODE: when you select this mode you can use the "chase" buttons (1) and chase/color fader (3) to choose one of the 32 predefined matrix chases. SPECTRUM MIX: select this mode if you want to select one of the 32 different colors using the "chase/color" fader (3). [. . . ] Each display shows the address the unit automatically received from the controller. Press the "red" button (see n°1) to set the addresses for matrix1 (first unit starts at address 001) or the "orange" button for matrix2 (first unit starts at address 193) D. Press the "blackout" button again for about 5 seconds, until the "blackout" LED stops blinking. Note: You can use the "full on" and "sound to matrix" buttons (see n°6 and 7) to switch between the 2 matrixes (first set of 8 units and second set of 8 units) POWER SWITCH: used to switch the unit ON/OFF 10. [. . . ]