[. . . ] Motor unit On/off switch Reverse switch Locking knob Mincing tube Feeding tube Feeding hopper Food pusher Feeding screw Cutting blade Mesh plate (coarse) Mesh plate (medium) Mesh plate (fine) Threaded ring Assortment of nozzles Our products are developed to meet the highest quality, performance and design standards. IMPORTANT SAFETY PRECAUTIONS When using electrical appliances, certain basic safety precautions must be followed, including the following: - Read all of the instructions before using. [. . . ] - This product must not be used by children or by other people without assistance or supervision if their physical, sensory or mental condition limits safe use of the appliance. Children must be watched to make sure that they do not play with the appliance. - If the power cord is damaged, it must be replaced by the manufacturer or its authorised technical service centre or by a qualified technician in order to avoid hazards. ASSEMBLY 1 Insert the feeding screw in the mincing tube with the long end of the shaft first. Make sure that the mesh plate notches fit in the mincing tube grooves. Note: It may be necessary to loosen the locking knob to enable full insertion of the mincer head. 6 Fasten the mincer head by turning the locking knob until it is tight. 8 Use the food pusher to gently push the food, one piece at a time, into the tube. DIRECTIONS FOR USE - Place the assembled appliance on a stable work surface, so that the ventilation holes on the base and rear of the appliance are not blocked. NOTE: If the motor loses speed or stops, it may be due to stuck food. If it is still stuck, stop the mincer, unplug it, disassemble the head and clean the inside parts. TIPS FOR THE MESH PLATE The recommended uses for each of the mesh plates are the following. [. . . ] If this happens, stop the mincer, wash the parts in hot water and reassemble. Whenever possible, mince pieces of dry bread in between meat mincings. [. . . ]