[. . . ] The appliance is intended to be used for vacuuming dirt and dust particles. Do not use it to vacuum large objects which block the appliance and can damage it as a result. If you move the appliance into another room, always disconnect the plug at the wall socket and carry the appliance by the handle.
7
Never move the appliance by pulling on the power cord. The mains plug must always be disconnected at the wall socket before changing the dust bag, cleaning the appliance or other care measures. [. . . ] Fabric Master: Cleaning roller for cleaning textiles and fabrics, e. g. Use one of the three brushes above or the Fabric Master depending on the requirements. 2 Alter the switch on the combi-floor brush depending on the carpet thickness.
Vacuum brush attachment
Use the vacuum brush attachment 2 to clean furniture, picture frames, books, etc. 2 Push the vacuum brush attachment 2 onto the narrow crevice tool 1 .
2
Narrow crevice tool
Use the narrow vacuum tube 1 to clean places difficult to reach, e. g. 1 Push the brush or Fabric Master onto the telescopic vacuum tube A .
Note 7 The narrow vacuum tube and vacuum brush attachment are stored in the accessories holder.
1
Note 7 Alternatively the crevice can also be pushed onto the elbow tube B .
18 ENGLISH
USE
________________________________________________________________________
Check whether the mains voltage given on the rating plate (on the underside of the appliance) matches the local mains voltage.
2 Firmly push together the two vacuum tubes with A and B , turning slightly.
Preparation
Your appliance is supplied with a dust bag already fitted. Once you have assembled the individual parts the appliance is ready to use. 1 Push the plug-in contact of the elastic hose C in the socket provided on the dust container until it latches into place.
3 Insert the handle section of the vacuum hose in the upper end of the vacuum tube and insert the floor brush in the lower end. 4 Fit together all the plug-in connections with a push and turn movement and undo them with a pull and turn movement.
Note 7 To remove the elastic hose C , press the side release buttons on the plug-in contact and then pull out the hose.
ENGLISH 19
USE _________________________________________________________________________
Switching on and off
1 Pull out the required length of power cord by pressing pushbutton E . 4 Set the required suction power with switch F .
F
E
gelb
5 After use, press pushbutton G to switch off the appliance and remove the power cord plug from the wall socket. Important 7 If the appliance is not being used, always disconnect the mains plug at the wall socket.
rot
2 Plug the power cord plug into the wall socket. 3 Switch on the appliance by pressing pushbutton G .
G
20 ENGLISH
USE _________________________________________________________________________
Rewind power cord
1 Unplug the power cord plug from the wall socket. 2 Hold the power cord in one hand and press pushbutton E , keep it pressed. 3 Carefully guide the power cord back into the appliance.
E
Important 7 Always rewind the power cord with care as pressing one side of pushbutton E and a high rewinding speed can cause unforeseeable cable movements.
ENGLISH 21
CLEANING AND CARE ________________________________________
Change dust bag
If the indicator M on the dust container changes to red you must change the dust bag. 4 Seal the dust bag by pushing the tab of the cardboard reinforcement into the opening. 5 Dispose of the sealed dust bag.
M
Important 7 Do not try to empty and reuse the dust bag. 7 Close the cover of the dust container.
1 Unplug the power cord plug from the wall socket. 2 Open the dust container by pressing the release button K of the dust container and lifting up the cover.
Note 7 Test the appliance after changing the dust bag. If the indicator is still red, the tools, hoses or filter are blocked (see following section). The cover of the dust container cannot be closed unless a dust bag has been inserted.
3 Push the filter holder forward.
22 ENGLISH
CLEANING AND CARE ________________________________________
Clean the filter or replace it . . .
Important 7 The dust bag and filter must be inserted before starting up the appliance as otherwise the motor will be damaged. 5 Shake out the filter, then wash it in hot soapy water, rinse well and leave to air dry.
. . . [. . . ] 7 If the appliance still won't work, please contact your dealer or the GRUNDIG service centre.
Correcting faults yourself
The appliance is equipped with a fuse disconnector, which automatically switches off the motor if it overheats. In this case, complete the following steps: 1 Switch off the appliance and disconnect the mains plug from the wall socket. 2 Look for the cause of the overheating (blocked hoses/tubes, dirty filter etc. ).
24 ENGLISH
INFORMATION _____________________________________________________
Environmental information
This product has been made from high-quality materials and parts, which are suitable for recycling and can be reused. Therefore, at the end of its life, the product must not be disposed of in the normal domestic waste but must be taken to a collection point for recycling electrical and electronic appliances. [. . . ]