[. . . ] 3 - Terminal lugs Oven racks 2 - #12 x 1/" screws (for mounting anti-tip bracket) Anti-tip bracket (taped inside upper oven with package containing literature) Anti-tip bracket must be securely mounted to back wall or floor. Thickness of floor may require longer screws to anchor bracket to subfloor. If using a power supply cord: A UL listed power supply cord kit marked for use with ranges. The cord should be rated at 250 volts minimum, 40 amps or 50 amps that is marked for use with nominal 1³/" (3. [. . . ] **If connecting to a 50-amp circuit, use a 50-amp rated cord with kit. For 50-amp rated cord kits, use kits that specify use with a nominal 1³/" (34. The range can be connected directly to the circuit breaker box (or fused disconnect) through flexible or nonmetallic sheathed, copper or aluminum cable. 4 cm) of slack in the line so that the range can be moved if servicing is ever necessary. A UL listed conduit connector must be provided at each end of the power supply cable (at the range and at the junction box). The Tech Sheet is located on the back of the range inside a clear plastic bag. If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate and wire gauge are in accordance with local codes. Be sure that the electrical connection and wire size are adequate and in conformance with CSA Standard C22. 1 , Canadian Electrical Code , Part 1 - latest edition , and all local codes and ordinances. A copy of the above code standards can be obtained from: Canadian Standards Association 178 Rexdale Blvd. Toronto, ON M9W 1R3 CANADA Check with a qualified electrical installer if you are not sure the range is properly grounded. This range is equipped with a CSA International Certified Power Cord intended to be plugged into a standard 14-50R wall receptacle. Be sure the wall receptacle is within reach of range's final location. *The NEC calculated load is less than the total connected load listed on the model/serial rating plate. **If connecting to a 50-amp circuit, use a 50-amp rated cord with kit. For 50-amp rated cord kits, use kits that specify use with a nominal 1³/" (34. If range height adjustment is necessary, use a wrench or pliers to loosen the 4 leveling legs. This may be done with the range on its back or with the range supported on 2 legs after the range has been placed back to a standing position. NOTE: To place range back up into a standing position, put a sheet of cardboard or hardboard in front of range. Using 2 or more people, stand range back up onto the cardboard or hardboard. Excessive Weight Hazard Use two or more people to move and install range. Place them lengthwise on the floor behind the range to support the range when it is laid on its back. [. . . ] For more information, read the "Range Care" section of the Use and Care Guide. If range does not operate, check the following: Household fuse is intact and tight; or circuit breaker has not tripped. Connect line 1 (black) and line 2 (red) wires to the outer terminal block posts with 10-32 hex nuts. Make sure the anti-tip bracket is installed: Look for the anti-tip bracket securely attached to floor or wall. [. . . ]