[. . . ] For use only with front load washers and dryers NOTE: If the washer/dryer and pedestal assembly are located in a garage, 3" (76 mm) must be added under the pedestal so that the washer/dryer is 18" (460 mm) above the garage floor. IMPORTANT: If your washer and dryer are already installed, they must be uninstalled. [. . . ] The front of the pedestal cabinet should align with the washer cabinet as shown below. Slide the pedestal's keyhole slots back over the lower two partially installed screws. To avoid floor damage and ease installation and handling, fold the empty pedestal box flat and place it next to the washer. Position the pedestal toward the front of the washer and install the two remaining hex-head sheet metal screws. Leave a space of about 3/8" (10 mm) between the screw head and the bottom of the dryer. To avoid floor damage and ease installation and handling, fold the empty pedestal box flat and place it next to the dryer. The front of the pedestal cabinet should align with the dryer cabinet as shown below. Position the pedestal toward the front of the dryer and install the two remaining hex-head sheet metal screws. Set the pedestal box aside for use when installing the pedestal on the dryer. Washer shown Align the sides of the pedestal so that they are even with the sides of the washer/dryer. [. . . ] Reach inside the pedestal and use a 1/4" hex-head ratchet or open-end wrench to adjust the feet up or down as needed, to level the washer/dryer. NOTE: Make sure all four pedestal feet are in solid contact with the floor. [. . . ]