[. . . ] QUICK SET-UP
ENGLISH
The following steps will quickly lead you through set-up and adjustments for the projector connected to a single computer. Before connecting, please remember to switch off the computer and disconnect the projector power cord.
SETTING UP
POWER OFF (1) Switch off all equipment before connecting. SOUND (3) Connect sound from the computer using an optional3. 5 mm stereo jack cable. POWER ON (7) First switch on the projector, then the source equipment for correct recognition of the projector.
USE
ZOOM , FOCUS AND POSITION Zoom the lens for desired image size, focus the lens for an optically sharp image and tilt the unit using the integral adjustable feet to position the image on screen. [. . . ] Use the remote control or the projector keypad to adjust settings, either directly or through the menu system. Try using a patterned background (tiles, checkerboard pattern etc) when adjusting the image.
1 2
1. Place the projector at a suitable distance to the projection screen; alternatively zoom the image, to obtain the desired screen size. (See the Technical Data section for max and min projection distances. ) Focus the image and observe that the picture elements (pixels) become sharp on screen. The projector has two
15
USER GUIDE
XGA LCD PROJECTOR
adjustable feet in the front, so that the image can be shifted to a desired height on the wall. Tilt the projector body in the desired position and press the foot-release buttons. If necessary, fine adjust the height by screwing the feet either direction. RESET in most cases automatically adjusts the image position, width (FREQUENCY) and stability (TUNE). If RESET fails to adjust the image correctly, see FREQUENCY, POSITION and TUNE below. CONTRAST and BRIGHTNESS may be adjusted according to your personal taste, the image and the viewing conditions. The controls are directly accessible on the remote control and on the projector keyboard. A wrong frequency setting can be seen as equally spaced, vertical stripes or irregularities in the pattern displayed. Adjust the value up or down using the trackball or keyboard cursor controls, observing that the amount of vertical stripes reduces, until the distortion is gone. POSITION the image correctly by accessing SET-UP, POSITION, then press ENTER and adjust position with the trackball or keyboard cursor controls 6. Set-up should be done once with the source(s) you are using most frequently. Allow some minutes for the unit to warm up before adjusting the settings. Most settings will be memorized individually for each source for future use.
16
USER GUIDE
XGA LCD PROJECTOR
8 USING THE PROJECTOR
The projector has a set of features and functions you should familiarize with in order to get the most out of using the unit.
8. 1
REMOTE CONTROL
The remote control is used to adjust the projector for the best possible image, either directly or through the menu system. It is also used during presentations for computer mouse control and with special presentation tools. The remote control may be pointed directly at the projector front or rear, where the receivers are situated, or indirectly by pointing at the projection screen. When pointing at the screen, point at an angle that reflects the beam towards the projector.
3 1
2
4 6
8 7
5
1. Bottom Key (Drag)
Not applicable for this product
17
USER GUIDE
XGA LCD PROJECTOR
The trackball is by default controlling the computer mouse (if the mouse cable is connected properly). With some functions, like POINTER, MASK and in the menu system, the mouse control is disabled. [. . . ] Having taken out the ball, you may also clean the trackball interior using a damp (not wet) cotton swab. To change the batteries, open the battery holder on the rear of the handset. Insert new batteries of the type described in the Technical Data section, observing the polarity instructions inside the battery holder, and close the snap lock door. Switch the remote control back on by using the ON/OFF-switch on the right hand side of the remote. [. . . ]