[. . . ] 600-1054-95R Simon XT User Manual g Copyright Copyright © 2007 GE Security. This document may not be copied in whole or in part or otherwise reproduced without prior written consent from GE Security except where specifically permitted under US and international copyright law. Document number: 466-2266C (November 2007). Disclaimer The information in this document is subject to change without notice. ("GE Security") assumes no responsibility for inaccuracies or omissions and specifically disclaims any liabilities, losses, or risks, personal or otherwise, incurred as a consequence, directly or indirectly, of the use or application of any of the contents of this document. [. . . ] This condition occurs after a complete loss of power (AC and battery). When power is restored, the panel will return to the arming state with the same zones bypassed it had prior to losing power. This condition occurs if a sensor is not communicating with the panel. Press the STATUS button and the display will show what sensors have failed. You may need to call your security system dealer if the problem continues. Press the STATUS button and the display will show what sensors have a low battery. You may need to call your security system dealer to resolve this problem. This condition occurs if your security system cannot communicate to the central monitoring station. Your system will try to report to the central monitoring station eight times before it tells you there is a fail-to-communicate problem. Press the STATUS button and the display will show Comm Test Fail or Comm Failure. You may need to call your security system dealer if the problem continues. 24 Simon XT User Manual Sensor open. This condition occurs if a door or window is open or a system sensor has been disturbed and not reset properly. For example, a door/window sensor magnet may have been removed from the sensor. Your system will indicate this condition to you by causing the STATUS button to light. When you press the STATUS button, the display shows, for example, Sn 1 Front Door Open. This condition occurs when a sensor is physically tampered with, for example, the cover is taken off of one of the sensors. Your system will indicate this condition to you by causing the STATUS button to light. The system will call to notify the central monitoring station about this problem. Some types of status conditions, such as the alarm history, must be cleared manually. To clear system status, press the STATUS button, read and/or listen to the status messages, then press DISARM. If the trouble condition was a low system battery, perform a sensor test. The STATUS light should turn off if all trouble conditions have been corrected. Chapter 4 Programming This chapter describes how to program your system. It will guide you through programming instructions for system features. [. . . ] 11 siren options . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33 smoke and heat detector locations. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43 smoke detector. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2, 3 speaker volume. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]