[. . . ] Exploded View of Wash System Standard Dry Air Flow When the control advances to the "dry" portion of the cycle, a linear actuator retracts a valve, which opens a vent path through the console into the kitchen. The heated, moist air leaving the dishwasher through the console vent causes drier air to be drawn into the unit by way of intake vents located at the bottom of the door. [. . . ] Center the gasket (marked on back) at the tub top center and press in place without stretching or bunching. The gasket takes a short turn at the bottom of the tub channel before ending at the channel end wall. Detergent cover will not latch or open. Replace dispenser. Dishwasher will not pump out. Gasket Cross Section Pump Assembly The pump assembly is driven by a synchronous motor. The motor drives a pump which supplies 100 percent filtered water at a rate of approximately 12 GPM to one spray arm at a time. The spray arm's operation is alternated by small "pauses" of the motor during the wash cycle. is attached by a worm gear clamp to the discharge end of the drain pump. The drain hose must have a loop at a minimum height of 32 inches in order to insure proper drainage. Mounting Rib Dishwasher will not fill with water. 1. Clean float. The main pump can easily be removed by disconnecting the upper spray arm supply tube hose, the drain pump connector hose, the wiring Draining is accomplished by using a small harness connections made at the circulation separate synchronous drain pump mounted to motor, the water heat thermistor located on the the side of the sump. The drain pump is bottom of the pump and rotating the four sump connected to the main pump by a small rubber retainers toward the middle of the sump. The drain check valve is located at the discharge end of the drain pump. [. . . ] While in Idle Mode, simultaneausly press the HI-TEMP WASH and START/CANCEL pads for 6 seconds. Pushing the START/CANCEL pad will advance the dishwasher to the next step. Cycle Selection Options [. . . ]