[. . . ] This Plasma TV can receive and decode ANY digital signal (HDTV, EDTV, or SDTV). However, the display is always EDTV. BEGIN CHANNEL SEARCH NOTE: Before beginning channel search, point your antennas toward the transmitting tower(s). [. . . ] Press CHANNEL UP to start Channel Search. Plasma TV Back UHF L I TA A I N DIGTENN L I TA O A N D I GA U D IT P U T OU SER VIC E /VH F/C AT V UHF/VHF/CATV DIGITAL ANTENNA IN First Please connect all signals and antennas to jacks and the terminals on the back. Then press Channel UP key. ADDING NEW DIGITAL CHANNELS DIGITAL ADD-ON SEARCH Use this feature to add new digital channels or to add digital channels with broadcast towers that are in opposite directions from your home. If necessary, after the initial search, turn the antenna and use the On-Screen Menu to perform a Digital Add-on Search. Repeat these steps for each direction in which there are transmitting towers. A Digital Add-on Search may take several minutes to complete. NOTES: Digital Add-on Search will not affect channels already in the channel database. Go to www. antennaweb. org and type in your zip code to obtain specific tower vector information. 3 4 5 Use the CURSOR LM keys to highlight the Channel category. These composite connectors (standard analog A/V and S-Video) are included on your new Digital TV to provide continued compatibility with older analog devices, such as a VCR. If you have an S-Video connector on your old analog equipment, you should use it instead of the standard video connector. Audio/Video VCR IN FROM ANT. IN R-AUDIO-L OUT R-AUDIO-L VIDEO VIDEO RF CHANNEL S-Video AUDIO OUTPUT VIDEO 1 COMPO 2 COMPO 3 S-VIDEO VHF/UHF TO TV OUT Y Pb Y RESET 3 S-VIDEO OUT 4 Pb Pr SERVICE L R V L R L (MONO) AUDIO Pr L R 1 Connect your external equipment as shown here, matching connector colors to jack colors. (Cables are not supplied. ) R Plasma TV Back DIGITAL AUDIO OUTPUT CONNECTION CONNECTING THE DIGITAL AUDIO OUTPUT TO A MULTI-CHANNEL RECEIVER Dolby® Digital Audio provides 5. 1 channels of surround sound (five full-range channels [5] and one low-frequency effect channel [. 1]). A fiber optics cable is used to carry the 5. 1 surround sound (for low-noise signal transfer). Multi-Channel Receiver Back of Plasma TV Optical Digital Cable DIGITAL DIGITAL AUDIO ANTENNA IN OUTPUT 1 Using a Fiber Optics cable, connect the TV's Digital Audio Output to the Digital Audio Input of a Multi-Channel Receiver. (Fiber optics cable is not supplied. ) NOTES: When making the connection, be careful not to bend the fiber optics cable too sharply. [. . . ] Red light visible at the Digital Audio Output does not necessarily indicate that Dolby® 5. 1 audio is available. Digital audio is made up of light pulses that the human eye cannot detect. [. . . ]