[. . . ] = 2. 5 l
2. 5 l of water eliminated
5l
2, 5 l
There is another way to decrease the relative humidity level. Increasing the temperature is equivalent to increasing the capacity of the container. When the air is at a temperature of 20°C, it is the equivalent of a 10 litre container, while at 30°C it is the equivalent of a 20 litre container. = 5 l
no water eliminated
5l 5l Of course, just increasing the room temperature is not the solution to your excess moisture/condensation problem. [. . . ] · The appliance is not intended for use by young children or the infirm without supervision. · The appliance must be connected to an efficient earth installation. · Before cleaning or maintenance operations, always unplug the appliance from the mains. · Do not install the appliance in rooms containing gas, oil or sulphur. · Keep the unit at least 50 cm away from inflammable substances (alcohol etc) or pressurised containers (eg. · The refrigerant used in this appliance would cause damage to the ozone layer if relased into the atmosphere. Therefore at the end of the working life of the appliance the unit should be taken to a recycling centre for disposal of the refrigerant. You are therefore recommended to dispose of them in special differentiated waste collection containers. These instructions are not intended to cover as many as possible conditions and situations which may arise. As with all household appliances installation, operation and conservation should be carried out prudently and following common sense.
Important
Techni El
cal assistance Keep the list of Technical Service Centres and identify the Centre nearest you.
ectrical connections
After moving the appliance, wait at least an hour before turning it on again. Before plugging the appliance into the power socket, check that: · The mains power supply corresponds to the power supply indicated on the rating plate. · The power socket and electrical circuit are adequate for the appliance. If this is not the case, have the plug replaced by a qualified electrician; · The power socket must be adequately earthed; Failure to respect this safety rule absolves the manufacturer from all liability. This appliance is manufactured in compliance with EEC standard EN 55014 on the suppression of radio interference. · If the supply cord is damaged, it must be replaced by the manufacturer or it's service agent or a similarly qualified person in order to avoid a hazard. 5
Installation
Pl
ace the dehumidifier in a suitable position, a hallway or landing are generally good sites. The appliance must be positioned so that the air intake and air outlet grills are at least 50 cm away from any wall or obstacle to ensure adequate ventilation.
Condensate can be drained in one of two ways: A) Draining into the tank The condensate can be drained directly into the tank located inside the appliance (fig. 1). The tank can be easily removed and has a handle making it simple to carry and empty.
fig. 1
B) Continuous external draining If the appliance is to be operated for long periods of time but you are unable to empty the tank, you are recommended to use the continuous drain facility. 2) Make a hole in the tank inside the spout using a fine drill bit (8mm) (Fig. 3) To fit the rubber hose to the spout, open the door, remove the tank, pass the drain hose provided through the space between the door (at a slight angle) and the bottom of the appliance, reposition the tank and fit the hose onto the spout (Fig. 5) Make sure the hose is on the level otherwise the water will remain in the tank. N. B. : Keep the rubber bung. You will need it to plug the hose or close the spout if you revert to draining into the tank (see point A).
fig. 2
fig. 3
6
De s c r i p t i o n o f c o n t r o l s
Dehumidifying mode OFF position: appliance off Dehumidifying indicator light Combined dehumidifying / heating mode
to heat and dehumidify simultaneously
Heating indicator light
Air circulation Heating mode
Minimum indicator light Speed/Heat setting selection button Maximum indicator light
Thermostat knob Power indicator light
indicates that the appliance is connected to the mains
Humidistat knob Dehumidifying standby light
lights up for the first three minutes in dehumidifying mode
"Tank full / no tank" indicator light
Tank control system
This dehumidifier is fitted with a special intelligent device to ensure correct operation. [. . . ] If the set temperature is higher than the room temperature, the ( )light comes on together with the dehumidification pause light ( ) for the first three minutes (safety device), followed by the dehumidification light ( ). 6) Select maximum or minimum fan speed (and consequently the electrical power). 7) When you have reached the desired humidity, slowly turn back the humidistat knob anticlockwise until the dehumidifying light and the heating light if still on, go out. Note: The appliance only stops completely when the level of humidity set is reached. [. . . ]