[. . . ] Failure to respect the above could reduce the safety of the appliance. · The power cable of this appliance must never be replaced by the user as it requires the use of special tools. If the cable is damaged or requires replacing, contact an authorised service centre only to avoid all risks.
Read this manual thoroughly before installing and using the appliance. This will ensure optimum performance and safety.
DESCRIPTION
(See drawing on page. [. . . ] Use medium ground coffee as excessively finely ground coffee could clog the filter (coffee for MOKA coffee makers can be used). To attach the filter holder to the appliance, hold it under the boiler outlet (fig. Push the filter holder upwards and at the same time rotate it towards the right as far as it will go. Make sure the filter holder is firmly in place, the position of the filter holder handle with respect to the appliance is irrelevant. 7 The jug must be positioned under the filter holder in such a way that the spout of the filter holder is inside the opening in the cover of the jug (fig. 7). 8 Position the selector (A) to the type of coffee you want to obtain: "LIGHT" for light coffee, "MEDIUM" for normal coffee, "STRONG" for strong coffee (fig. 8). 9 Make sure the steam knob (F) is fully closed and press the luminous switch. IMPORTANT: To avoid discharge of steam, before removing the filter holder, always vent all steam
FITTING THE ADAPTER
To make coffee directly in the cup, the adapter (R) must be used. To fit, simply insert it in the bottom part of the filter holder (fig. 12).
PREPARING CAPPUCCINO COFFEES
· Pour the quantity of milk required to make the cappuccino coffees (about 100 cc for each cappuccino) into the milk tank (E) (fig. Never exceed the MAX level (corresponding to about 250 cc) marked on the tank (fig. 14) otherwise milk may continue to drip from the milk tank tube after frothing has been completed. When preparing four cappuccino coffees, the milk in the tank must be topped up. · Prepare the coffee as described in the paragraph "PREPARING THE COFFEE" from point 1 to point 8, but using more water as specified in the table at the end of the manual. When the coffee reaches either the 2 or 4 level indicated on the jug, stop delivery of the coffee by placing the coffee selector in the "CAPPUCCINO" position. IMPORTANT: The 2 or 4 mark should correspond not to the level of the light coloured cream, but to the darker coloured coffee under the cream. If the level of coffee exceeds the 2 or 4 line, there will not be sufficient steam to froth the milk. · One at a time, place the cups containing the coffee under the milk tank tube (fig. When using small cups, to avoid splashes of milk, fit the splash hood (G) onto the milk tube (fig. · Rotate the steam knob anticlockwise to discharge the frothed milk from the tube (fig. For correct frothing and to avoid splashes of milk, rotate the knob at least one turn. Continue until half the milk has been emptied from the tank, then shut off the steam by rotating the knob clockwise. · Repeat the operation for the number of cups required until the milk tank is empty. [. . . ] When the solution stops flowing into the jug, turn off and allow the machine to cool down. To remove traces of descaler, perform at least 2 coffee-making cycles without coffee. Failure to clean as described above invalidates the guarantee.
CLEANING AND MAINTENANCE
Before cleaning or servicing, disconnect the appliance by removing the plug from the socket.
Cleaning the milk frother
The milk frother must be cleaned each time you use the appliance. Proceed as follows: · Remove the milk tank by pressing the "PRESS" lever and at the same time pulling upwards. [. . . ]