[. . . ] NOTE: If you have an internal drive, refer to the other side of this card for installation instructions. Copyright © 2005 by Quantum Corporation. Other product names are trademarks or registered trademarks of their respective owners. Quantum reserves the right to change, without notice, product offerings or specifications. [. . . ] · Always place the drive on top of or inside the antistatic bag to reduce the chance of ESD damage. · Due to the speed of the LTO-3 drive, it is recommended that a maximum of one LTO-3 drive be connected to one host SCSI adapter. . NOTE: If you have a desktop drive, refer to the other side of this card for installation instructions. Internal Tape Drive Jumper Settings Back Panel of the Internal Tape Drive Before installing the drive, read the following instructions: · Install LVD drives only in an LVD environment. · Due to the speed of the LTO-3 drive, it is recommended that a maximum of one LTO-3 drive be connected to one host SCSI adapter. If any item is damaged, please contact your place of purchase immediately. In addition to the contents included with your desktop tape drive, you need the following items: · A SCSI host bus adapter that is properly installed and configured in a host computer · A 68-pin SCSI cable · Backup application software that supports the tape drive. For a list of the latest backup software applications tested with the LTO-3 tape drives, please visit our Web site at www. quantum. com/support. Review the drive's default settings and change them if necessary. (For detailed information, please refer to your User's Guide on the Resource CD. ) · SCSI ID: 6 4. Attach the SCSI interface cable to either of the two 68-pin SCSI interface connectors on the back of the drive. SCSI Termination Examples for the Desktop LTO-3 Tape Drive SCSI Terminators External SCSI device Drive Configuration Jumper Pins 1. Turn off all power to the computer in which the drive will be installed. If any item is damaged, please contact your place of purchase immediately. In addition to the contents included with your internal tape drive, you need the following items: · A SCSI host bus adapter that is properly installed and configured in a host computer · A 68-pin SCSI cable and a 68-pin LVD SCSI terminator · Backup application software that supports the tape drive. For a list of the latest backup software applications tested with the LTO-3 tape drives, please visit our Web site at www. quantum. com/support. [. . . ] Register your tape drive at: www. quantum. com/registration. SCSI Termination Examples for the Internal Tape Drive SCSI Terminator SCSI device (termination enabled) External Tape Drive 9. To connect the tape drive to a tape library, connect a serial cable to the RS-422 connector on the lower left side of the back of the tape drive. Connect a 4-pin power cable to the power connector on the back of the tape drive. [. . . ]