[. . . ] Start Your Installation ------------------------------------------------- 4 7. Setting Up The Dome Lamps ----------------------------------------- 5 8. Installation Your Monitor--------------------------------------------- 6 9. [. . . ] Closing Monitor ------------------------------------------------------ 7 11. OSD Menus in A/V Source -------------------------------------------8 12. Remote Control----------------- --------------------------------------9 13. Appendix--------------- -----------------------------------------------9 14. Specifications --------------------------------------------------------10 WARNING This unit is not intended for installation in the front Driver /Passenger Compartment where it may be seen by the Driver. Installation of this unit in any portion of the vehicle which could impair or distractthe Driver is improper and dangerous and assumes No liability whatsoever for failure to follow the proper installation of this product. To reduce the risk of electric shock, please do not expose this unit to rain, moisture or open the unit. Dangerous high voltages are present inside the unit. Our warranty could be voided if you make changes or modifications not expressly approves by 1 1 Usage Notice Follow all warnings, precautions and maintenance as recommended in this user's manual to maximize the life of your LCD monitor To avoid the damage of the LCD monitor and risk of electronic shock, do not permeate the LCD monitor with water or any drink. When this happens, turn off the power, unplug the power cord and send the LCD monitor to your local dealer or our service cen-ter as soon as possible. Do not try to repair the power cord when it is damaged or broken, change a new one immediately. *The unit should not interfere with other vehicle components e, g (sliding sunroof). *Make sure the unit is installed to a secure, robust mounting location and cannot become dislodged in the event of an emergency stop. *If driving is required, take care not to penetrate through the other sheet metal of the vehicle. *Avoid prolonged use of the monitor when the engine is not running to prevent draining the vehicle battery. *Place the mounting metal plate with the nuts facing upward, then, mount the monitor by screws included 6 Operating the Monitor * Powering up the monitor The monitor will be automatically turned on when releasing the monitor from the base unit and "OFF" when it is closed. Operating Instructions Opening the Monitor 1. Lower the monitor until is fixed 90 from the monitor base unit for viewing (Refer to the following figure. ) Closing Monitor 1. Push the monitor back into the monitor base unit until the screen engages with the release button. 7 * OSD Menus in A/V Source A. SYNC = +60. 0Hz BRIGHTNESS CONTRAST COLOR HUE SOURCE AUDIO RECALL EXIT AUTO DETECT 1 VIDEO 1 VIDEO 2 RETURN B. Audio Input Selection Menu AUDIO MUTE VOLUME RECALL RETURN * Quick Adjustment OSD Menus 1. [. . . ] By pressing "MENU" button, you may open the MAIN MENU, using "+" or "-" together to pick out OSD functions. In order to select desire options, it is necessary to press "MENU" again to enter each mode, than using " "/ " " to increase or decrease parameters as well. 3. Press "+" or "-" button directly to adjust speaker volume. VOLUME 4. [. . . ]