[. . . ] CE DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents: EN 60 335, EN 61 000-3, EN 55 014, in accordance with the provisions of the directives 2006/95/EC, 2004/108/EC. If the cable is damaged or cut through while working, do not touch the cable but immediately pull the mains plug. [. . . ] Use completely unrolled and safe extension cords with a capacity of at least 5 Amps. The glue gun is intended for the quick gluing of clean, dry and grease-free materials with glue heated to its melting point. Do not allow the nozzle tip or hot glue to come into contact with persons or animals. If hot glue touches the skin, immediately hold the spot for some minutes under a stream of cold water. models 910 , 920 and 930: · Allow glue gun to reach operating temperature before using (±5mins). Once the cord is detached, the glue gun remains operable for 5mins, before it needs to heat up. NOTE: For your first use, you may need to load up to two full glue sticks before glue begins to flow. tIP: Dremel also supplies glitter and colour sticks for decorative purposes. These sticks have been specially developed for creative projects and low temperature (105 °C). To be able to quickly change colours, it is recommended to cut the sticks into 3 cm pieces before inserting into the Glue Gun. dual Temperature Glue Gun Model 930: · Adjust switch (5) to low or high temperature setting to turn the Glue Gun on. PREPARATIONS FOR GLUING The surfaces to be glued must be clean, dry and free of grease. [. . . ] This DREMEL product is guaranteed in accordance with statutory/country specific regulations; damage due to normal wear and tear, overload or improper handling will be excluded from the guarantee. If the unit should fail despite the care taken in manufacturing and testing, send it undismantled together with proof of purchase to your dealer. [. . . ]