[. . . ] Check in the Aurora system menu ­ info menu screen, for your Aurora software version. If not, You will need to update the Aurora software using the HPP-22 device. If not, You will need to update the module software using the HPP-22 device. If not, You will need to update the Aurora software using the HPP-22 device. Contents 3---------3---------4---------5---------6---------8---------9---------10 - - - - - - - - 13 - - - - - - - - 13 - - - - - - - - 1) Are You Updated? [. . . ] Take the length of the sensor wire leads into consideration before permanently mounting. Then, install the Sensor Station in your model using the supplied double-sided tape. c. Press "TEMP" The temp reading for any "unconnected" temp sensor will show -40. Note d. Press (arrow) to select between F(Fahrenheit) and C (Celsius) readings. 4 5 HTS-SS 2. 4Gz Telemetry Product Installation Guide 4. To customize the name of the temp sensor, press Temp-1, then the Rename icon. 2. 4Gz Telemetry Product Installation Guide 5. Install around the tail boom of your heli using the supplied zip ties. Point it straight up at the rotor disk avoiding any y bar paddles that will skew the results. HTS-SS f. To view the minimum, average and maximum temp readings for any of your installed temp sensors, note the numbers when any one of the sensors is selected on the screen. For prop driven aircraft, use double sided tape to attach the sensor in the airfame with the front of the sensor aimed at the revolving propeller. 5. RPM Sensor There are two di erent RPM sensors available for use on the Hitec telemetry system. Optical RPM Sensor (HTS-ORPM) - provides RPM information using a optic sensor. Indoor lighting and outdoor lighting variations can a ect the readings of the optic sensor. Note Magnetic Sensor Installation A. The magnetic sensor consists of two main parts, the sensor and magnet. The typical installation will have the sensor mounted on the motor mount or airframe, and one magnet attached to the spinner backing plate or prop hub in such a way as to "trigger" a signal every time the rotating magnet passes in front of the stationary sensor. It is suggested a small hole be drilled in the spinner backing plate, or prop hub into which one of the magnets is set ush using hobby CA. Note the tolerances here are very tight, the distance between the sensor and spinning magnet need to be 1mm. Each magnet has a X mark to identify polarity, please make sure the X mark to be faced out. Magnetic RPM Sensor (HTS-MRPM) - provides RPM information using a magnetic sensor. This is used for aircraft with propellers, ducted fans, heli tail rotors and main gears. The edit function as described at the end of this document in the HPP-22 data display. To use the Magnetic sensor with heli main gear / head speed ratios Note There are two slots in the Sensor Station for RPM sensors. Press the RPM-1 icon and then RENAME to give the RPM-1 value a custom name. [. . . ] For the most accurate altitude information select the ABSOLUTE setting. 8. HPP-22 PC Interface The HPP-22 PC interface device is a handy accessory to have. In addition to updating the Aurora, Spectra 2. 4 module, Optima receivers and the HTS-SS sensor station, the HPP-22 when ported to the Spectra 2. 4 module can display the ight telemetry data on a PC. Install the HPP-22 software from the Hitec website at www. hitecrcd. com 2. [. . . ]