[. . . ] Before commencing assembly, please read these instructions thoroughly! Oe First-time builders should seek the advice of experienced modellers before commencing assembly and if they do not fully understand any part of the construction. [. . . ] Install carefuly the receiver and battery pack to ensure that they will not move during flights. B Adjust the travel of each control surface to the values in the diagrams. B , µ If necessary, re-position receiver and battery to get correct C of G. First time pilots should seek the advice of more experienced flyers during construction and for initial flights. Oe Initially, less experienced pilots should only fly with an experienced pilot, until they become more proficient. Installation of engines other than those specified could to lead to a serious accident and/or damage to property. Take out f uel i nsi Ide t he r ot at i ng f an cont act t he case, r em es e t he cyl i nder , and st ar t agai n af t er you r em a pl ug wi t hout pul l i ng i t f or cef ul l y. L , For the correct placement of decals, please refer to the box top and illustrations below. , Å Do not fly your airplane when there is a strong wind or a lateral wind. B Adjust the engine always from behind, but never from infront or the sides as a rotating propeller may badly injure you! [. . . ] B --, ³ Hand-launch your airplane into the wind to make it take off. B OE¯ Never throw burning, gleaming or smouldering things into fuel cans, even if these happen to be empty. [. . . ]