[. . . ] Transient Level: Less than 500mV peak, out to 100MHz. Power Supply Features J F G WJS 100 ST 50 O I P Q E H C ©2010 PACE Inc. , Annapolis Junction, Maryland All Rights Reserved Page 3 of 11 C E F G H I J O P Q Feature Power switch Power Receptacle Program button Up arrow button Down arrow button Digital control LED Digital display Ground jack ISB connection Power inlet with fuse Description On /off control of power supply. Connection for IEC power cord and fuse replacement. Safety Guidelines The following are safety precautions that personnel must understand and follow when using or servicing this product. POTENTIAL SHOCK HAZARD - Repair procedures on PACE products should be performed by Qualified Service Personnel only. Service personnel must avoid contact with these parts when troubleshooting the product. [. . . ] A display of the software version of the installed microprocessor (e. g. , "1-2") for 2 seconds on initial power up after the "888" is displayed. Actual tip temperature of the connected handpiece during normal operation. 4 The tip temperature displayed will flash when the system is in Temperature Setback. The displayed temperature will decrease and stabilize at 177°C (350°F) when the system is in Temperature Setback. "OFF" with stable display when the Set Tip Temperature has been set to Off (below minimum set tip temperature). "OFF" with flashing display when the unit has entered Auto Off. 8 Error messages ("OSE", "SSE" or "OCE") if a system fault is detected. Refer to the "Corrective Maintenance" portion of this manual. LED Display, Temperature Adjust Mode The LED Display will show the following when adjusting the desired Set Tip Temperature. "HiL" (High Temperature Limit) when adjusting the set tip temperature and the maximum allowable temperature is exceeded. "OFF" (Low Temperature Limit) when adjusting the set tip temperature and the minimum allowable temperature is exceeded. "EP" will be displayed if a Set Tip Temperature adjustment is attempted and a Password has been stored in system memory. The LED Display now shows the stored default High ("Hi") Temperature Limit with the display alternating to show "Hi" and the stored limit. Choose one of the following: a) Press and release the Program Key ( ) to keep the stored High Temperature Limit. b) Adjust the stored High Temperature Limit using the keypad c) Press and release the Program Key to proceed to the next step. The LED Display now shows the stored default Low ("Lo") Temperature Limit with the display alternating to show "Lo" and the stored limit. Choose one of the following: ©2010 PACE Inc. , Annapolis Junction, Maryland All Rights Reserved Page 7 of 11 a) Press and release the Program Key ( ) to keep the stored Low Temperature Limit. b) Adjust the stored Lo Temperature Limit (up to 482°C, 900°F) using the keypad. The LED Display now shows the stored Temperature Setback time as "S-X" (x=0 thru 9). Time is shown as tens of minutes (e. g. , "S-3" equals 30 minutes). Choose one of the following: a) Press and release the Program Key ( ) to keep the currently stored Temperature Setback time. To preserve tip life and save energy, the system can be programmed to automatically set back its Tip Temperature to 177°C (350°F) after a selected period of handpiece inactivity (adjustable 1090 minutes in Set-Up Mode). . Set Tip Temperature and Tip Offset values will be simultaneously restored. [. . . ] This warranty is available only to the first user, but the exclusions and limitations herein apply to all persons and entities. SELLER MAKES NO OTHER WARRANTY, EXPRESS OR IMPLIED, AND MAKES NO WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Seller will, at its option, repair or replace any defective products at its facility or other location approved by it at no charge to user, or provide parts without charge for installation by the user in the field at user's expense and risk. User will be responsible for all costs of shipping equipment to Seller or other location for warranty service. [. . . ]