[. . . ] 1 ELECTRO
2
Table of contents
General Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Information on protection of the environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Before using the appliance for the first time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 4 4 5 5 5 6 7 7 8 8 8 9 10 11 11 11 12 13 13 14 15 15 16 17
Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Intended use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Technical safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] To avoid damaging the hob, cover it when installing the extractor hood.
RISK OF FIRE Do not flambé under the extractor hood or work with a naked flame. Do not leave pans, frying pans or deep-fat fryers unattended if you are cooking food with oils or fats, e. g. A risk of fire can be prevented by cleaning the grease filters regularly and changing the activated-carbon filter in good time. Never operate the extractor hood without grease filters.
7
Operating modes
The extractor hood can be used in exhaust air and circulating air mode.
Exhaust-air mode
Appliance dimensions Exhaust air
min. 580 max 1. 030
The air which is drawn in is cleaned by the grease filters and conveyed to the exterior by a pipe system.
min. 450 400
Circulating-air mode
Appliance dimensions Circulating air
min. 580 max 1. 030
The air which is drawn in is cleaned by the grease filters and an activated carbon filter and conveyed back into the kitchen. An activated carbon filter must be installed to bind odours in circulating-air mode (see "Removing and installing the grease filters"). The complete installation set as well as the replacement filters are available from specialist outlets, customer service or the Online Shop. The accessory number can be found at the end of the operating instructions.
min. 450
8
Operation
The description of the operation applies to several appliance models. Clean carefully in the area of the controls to avoid liquid from getting into the electronics. NOTE: Clean the stainless steel surfaces in the direction of the ground surface only!Do not use stainless steel cleaner for the control buttons!
Cleaning the metal-mesh grease filters . . .
Under normal operation (daily 1 to 2 hours), the metal-mesh grease filters must be cleaned 1x month.
. . . in the dishwasher
The metal-mesh grease filters can be cleaned in the dishwasher. Slight discolouration may occur but this will not affect the function of the grease filters. NOTE: Do not clean heavily saturated metalmesh grease filters together with utensils.
. . . by hand
When cleaning by hand, soak the grease filters in a hot detergent solution, brush off the dirt, rinse thoroughly and leave to dry. If dirt is particularly stubborn, we recommend using a special grease solvent spray. This can be ordered via the Online Shop.
10
Removing and installing the grease filters
Before removing and installing the grease filters, always follow the instructions and warnings in the chapter entitled "Safety instructions"!Activated carbon filters bind the odours in circulating-air mode.
Removing and installing the metal-mesh grease filters
1. In doing so, hold the underside of the grease filters with your other hand.
Installing and removing the activated carbon filters
1. [. . . ] Connect the green and yellow (Earth) wire to the terminal in the plug marked `E' or with the symbol <, or coloured green or green and yellow. Connect the blue (Neutral) wire to the terminal in the plug marked `N' or coloured black. Connect the brown (Live) wire to the terminal marked `L', or coloured red. The required connection data can be found on the rating plate inside the appliance when the grease filters have been removed. [. . . ]