[. . . ] DHI 625 M AU
Operating and installation instructions
Internet: http://www. bosch-hausgeraete. de Bosch Info-Team: de Tel. 430
2
Instructions for use: Appliance description Operating modes
This can be achieved if combustion air can flow through non-lockable openings, e. g. in doors, windows and via the airintake/exhaust-air wall box or by other technical measures, such as reciprocal interlocking, etc. If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. [. . . ] The activated carbon filter is installed above the grease filter inside the extractor hood. Place wing nut and sleeve over screw, insert into housing and tighten firmly (applies only when installing filter for first time).
4. Renewing the activated carbon filter: Under normal operating conditions (1 to 2 hours per day), the activated carbon filter will require replacing approximately once per year. Replacement filters can be obtained from specialist retailers (see Optional accessories). In so doing you will be ensuring that the extractor hood performs as effectively as possible. Disposing of the old activated carbon filter: Activated carbon filters do not contain any pollutants and can be disposed of with domestic refuse.
Screw, sleeve and wing nut are enclosed with the activated carbon filter . 7
Cleaning and care
Disconnect the extractor hood from the electricity supply by pulling out the mains plug or switching it off at the fuse box. At the same time as you clean the grease filters, clean off any grease from all accessible parts of the housing. This significantly reduces the fire hazard and ensures that the extractor hood performs as effectively as possible. Use a hot detergent solution or a mild window cleaner to clean the canopy of the extractor hood. Do not scrape off any dirt that has dried on but loosen it up with a damp cloth. Do not use abrasive cleaning agents or sponges that could cause scratches. Note: Do not use alcohol (spirit) on plastic parts, otherwise the surface may become matt in appearance. Clean the operating buttons with a mild soapy solution and a soft, damp cloth only. Stainless steel surfaces: Use a mild non-abrasive stainless steel cleaner. Clean the surface in the same direction as it has been ground and polished. Do not use any of the following to clean stainless steel surfaces: abrasive sponges, cleaning agents containing sand, soda, acid or chloride!Aluminium, painted and plastic surfaces: Use a soft, non-linting window cloth or micro-fibre cloth. 8 For appliances with a glass plate in the pull-out vapour extractor: The glass plate is easily removed and can be cleaned in a dishwasher. Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box. Replace the bulb (standard filament bulb, max 40 W, E14 bulb holder).
4. Plug appliance into mains again or switch on at the fuse box.
Installation Instructions: Important information
Old appliances are not worthless rubbish. [. . . ] Align the 4 enclosed mounting brackets and screw them on tight.
12
Installation inside the wall cupboard
1. Align the cupboard doors if the hinges will no longer be accessible after the extractor hood has been fitted. Place the extractor hood onto the mounting brackets and push it into the cupboard. Cut holes for the pipe connection and the mains cable.
20 20
Important: The extractor hood must be firmly seated on the 4 mounting brackets. [. . . ]