[. . . ] boschhausgeraete. de
5600 047
206 (8205)
en
Index
4 6 7 8 9 10 11 Detergents . Filling the special salt container Filling the rinse-aid container Unsuitable dishes . .
en
Safety instructions
Delivery
Immediately check the packaging and dishwasher for any damage which may have been caused in transit. The wooden frames (if fitted) are made of residual wood and are untreated. [. . . ] Contact the manufacturer of the cleaning agent if you have any questions, particularly if: the crockery is very wet once the programme has finished. Any problems which arise as a direct result of the use of these products are not covered by our warranty.
If you are using detergent in tablet form, read the manufacturer's recommendations on the packaging in order to determine where the tablets should be placed inside the dishwasher (e. g. Make sure that the lid on the detergent compartment is closed, even if you are using tablets.
15
en
Programme overview
This overview lists the max. The programmes supplied with your appliance are indicated on the fascia. Type of crockery e. g. china, Nonpots/pans, delicate cutlery, glasses, etc. Type of food remains Soups, casseroles, sauces, potatoes, pasta, rice, eggs, roast or fried food a lot stuck on hard
Mixed
Soups, potatoes, pasta, rice, eggs, roast or fried food
Coffee, cakes, milk, sausage, cold drinks, salads very little
Amount of food remains Condition of food remains Wash programme
a little
Rinse off if the dishes have been stacked for several days in the dishwasher prior to washing.
loosely attached
Intesive 70°
Normal 65°
Eco 50°
Quick 35°
Pre-rinse
Programme sequence
Pre-rinse 50° Wash 70° First rinse Second rinse Third rinse Rinse-aid 70° Drying
Pre-rinse Wash 65° First rinse Second rinse Rinse-aid 70° Drying
Pre-rinse Wash 50° Main rinse Rinse-aid 65° Drying Wash 35° Main rinse Rinse-aid 55°
Pre-rinse
Programme selection
The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc. , as well as the amount and condition of food remains, with the details contained in the programme overview. You will find the appropriate programme information in the introduction. If only a small number of dishes have been loaded into the dishwasher, selecting a programme that operates at the next lowest temperature will usually suffice.
End of programme
The programme has come to an end when the PROGRAMME END indicator 3 and the indicator for the selected programme are both lit up. This function can be changed as follows: Hold down the function button C and switch on the main switch 1 . Each depression of function button C changes the buzzer in 4 stages (from off to loud). The setting is stored.
Programme data
The stated programme data are based on standard operating conditions. The values can vary considerably according to: different amounts of dishes temperature of mains water supply pressure of mains water supply ambient temperature fluctuations in mains voltage machine-related factors (e. g. Energy and water consumption is reduced by up to 1/4 when dishes are washed in the upper basket only. Water consumption values are based on a water hardness setting of 2.
Switching the dishwasher OFF
Several minutes after the programme has ended: Open the door when the programme has ended. (Does not apply when Aqua-Stop unit has been fitted) Remove dishes, etc. when they have cooled down.
Switching ON the appliance
Open water tap fully. This programme will be performed unless another programme button 6 is pressed. The programme starts automatically.
17
en
Programme interruption
Carefully open the door, it could happen that water splashes out of the appliance. If the programme is already in "drying" mode, an acoustic signal reminds you to close the appliance door or to abort the programme. If warm water is connected or if the machine is already heated up and the appliance door has been opened, leave the door slightly ajar, then close it, otherwise the appliance door can jump open through the expansion. In order to continue the programme flow, switch the main switch ON again and close the door.
Maintenance and care
You can help prevent faults by checking and maintaining your appliance regularly. Therefore you should occasionally examine the inside of your dishwasher.
Overall condition of the appliance
Check the rinsing compartment for grease and limescale deposits. [. . . ] Install the appliance in the following sequence: Check the delivery Install the appliance Connect the waste water Connect the fresh water Connect the power supply
Fresh water connection
Using the enclosed parts, connect the fresh water connection to the tap according to the installation instructions. Ensure that the fresh water connection is not kinked, crushed or twisted. When replacing the appliance, always connect a new water supply hose to the water supply. Ensure that the fresh water connection is not kinked, crushed or twisted. [. . . ]