[. . . ] Directions for Use
GB
EXTRAKLASSE 1300 Wash & Dry
Contents
Important information Notes on disposal
Page 3 3 3 4 5 6 7 8 9 10 11 12 14 14 14 15 16 17 18 20 21 22 23 23 23 24 24 24 24 25 25 25 25 26 27 28 29 32 33 Packaging of new appliance . .
Your new washer / dryer
Environmental protection / notes on saving . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Notes on detergent and preparing the laundry
First operation How to wash
Special programmes
Cleaning / Maintenance
Malfunctions Consumption data
2
Notes on disposal
Packaging of new appliance !Dispose of packaging material properly.
Notes on safety and warnings
This machine meets the relevant safety requirements. [. . . ] When the programme has ended, set the programme selector to the Off position.
16
Opening the porthole / loading the machine
Opening the porthole
Pull the opening handle on the porthole forwards.
Loading the machine
!Items which have been pretreated with sol
vent based cleaning agents, e. g. stain re movers, petroleum ether, must be allowed to dry in the open before washing. Please observe the maximum drum loads for the different wash programmes (pages 14 and 15). Ensure that no items of laundry are jam med between the door and the rubber seal. Close the porthole by pressing it shut until it engages audibly.
Measuring and filling detergent
see pages 11 and 13.
Opening the water tap
The water tap must remain open also during the drying cycle because cooling water is required.
17
Setting a wash programme
Your washer/dryer provides you with three washing modes: Washing only Drying only Continuous washing and drying cycle
Setting a wash programme
Set the programme selector to the required programme, e. g. continue with "Start", page 20.
Setting the drying time programme
Set the programme selector to the desired programme, e. g. To remind you that a drying time must still be set, the "Drying Time" control light flashes. continue with "Start", page 20.
Recommended drying times (minutes): Degree of dryness closet dry iron damp 2, 5 kg Cottons/ Coloureds 2 kg Easy Care 2 kg Delicates 80 70 65 65 45 45
Set shorter drying times for smaller laundry loads. To prevent overdrying of laundry which would cause it to shrink or crinkle, avoid se lecting excessively long drying times. This can easily lead to misjudgements.
18
Setting a wash programme
Selecting a continuous washing / drying programme
1. Setting a drying time automatically adds a drying programme to the active wash and spin programme, taking into account the type of laundry being washed. At the start of the drying cycle, the "Delay Start / Drying" display indicates the number of minutes of drying time remaining in the programme cycle. To protect the laundry in the case of wool pro grammes, erroneously selecting a drying time will not cause a drying cycle to be added to the wash programme. When washing temperature sensitive fabrics: Press the "Higher Water Level" button. This causes the drying temperature to be lowered in the Easy Care programme (dry ing of acrylics), and the Anti Crease func tion to be switched off.
19
Starting a programme / Programme sequence
Approximately two seconds after selecting the programme, the unit is ready to start. If the door is not shut properly a safety device prevents the machine from operating.
Press the "Start" button. The control light of the first programme segment of the selected programme illumi nates in the programme sequence display. In the case of drying programmes, locking the loading door causes the number of mi nutes of drying time remaining in the pro gramme cycle to be indicated in the "De lay Start / Drying" display. or if the start time is to be delayed: Hold the Delay Start" button down until the number of hours by which the start is to be delayed is displayed.
Changing the programme
see page 24.
Programme sequence
During washing, the lights in the programme sequence display show the programme sta tus, e. g. Rinsing.
Drying programme sequence
During the drying cycle the "Drying" control light in the programme sequence display illu minates. The "Delay Start / Drying" display indicates the time remaining in the drying cycle.
20
Ending the programmes without final spin cycle
If you have selected the No Final Spin"addi tional function, the laudry is in the last rinsing water. [. . . ] The programme has ended, the porthole is still locked The porthole can be opened: - when the "Door" light is off. - Suds pump is blocked.
Foam is visible after last rinse Motor noise Pump noise Vibrations when washing and spinning
The laundry has not been spun
Extended programme time
Porthole cannot be opened. The "Door" light is flashing The dryer does not function
30
Rectifying minor malfunctions yourself
If a control light is flashing in the programme sequence indicator on the operating panel, or a light is illuminated and a number appears in the Delay Start / Drying" time display, this is an indication of either a deviation from the normal programme sequence or an operational malfunc tion. If you notice one of the displays listed in the following, you can rectify the malfunction yourself.
Display
Control lights in the programme sequence display Pre Wash Drying Number in the Start time dis play 15
Possible causes / P ibl Remedial action
Porthole not closed. [. . . ]