[. . . ] boschhausgeraete. de
5600 049
517 (8205)
en
Index
3 4 5 6 7 8 9 Detergents . Filling the special salt container Filling the rinse-aid container Unsuitable dishes . .
en
Safety instructions
Delivery
Immediately check the packaging and dishwasher for any damage which may have been caused in transit. The wooden frames (if fitted) are made of residual wood and are untreated. [. . . ] 5 litres when the dishes are only "slightly" dirty.
Switching the dishwasher ON
Turn on the tap. Indicators light up according to the last programme that was selected. This same programme will run again if no other programme button 6 is pressed. For appliances with top basket feature: If only the top basket is loaded, press the top-basket button 5 . The programme starts automatically.
Programme data
The stated programme data are based on standard operating conditions. The values can vary considerably according to: different amounts of dishes temperature of mains water supply pressure of mains water supply ambient temperature fluctuations in mains voltage machine-related factors (e. g. Energy and water consumption is reduced by up to 1/4 when dishes are washed in the upper basket only. Water consumption values are based on a water hardness setting of 4.
End of programme
The programme has ended when a figure appears in the numerical display 3 .
Switching the dishwasher OFF
Several minutes after the programme has ended: Set the main switch 1 to OFF. (Does not apply when Aqua-Stop unit has been fitted) Remove dishes, etc. when they have cooled down.
Aquasensor *
* on applicable models The Aquasensor is an optical measuring device with which the cloudiness of the water in the dishwasher is measured. A photoelectric sensor is used to detect the degree of soiling in the water, caused by dissolved food particles such as egg, fat and rolled oats, etc. The Aquasensor functions during all programmes that include a pre-rinse cycle. If the water is still "clean" at the end of the pre-rinse cycle, then the same water is used for the following wash cycle. If the water is dirty, it is pumped out of the dishwasher and replaced by fresh water.
15
en
Interrupting the programme
Set main switch 1 to OFF. If the hot water was switched ON or the appliance has already heated up and then the appliance door opened, leave the door ajar for several minutes and then close. In order to continue with the stored programme, set the main switch to ON again.
Cancel programme (Reset)
Only when the master switch is ON. Press the A and C buttons simultaneously, and hold them pressed for approx. To restart the dishwasher, set main switch 1 to ON again and select desired programme.
Programming the timer
You can delay the start of a programme in increments of one hour for up to 19 hours. Press the TIMER button as many times as necessary until the numerical display shows the required delay. To erase the time delay setting, keep pressing the TIMER button until appears in the numerical display. You can change your programme selection as often as you like during the intervening period before the dishwasher starts up.
Changing the programme
It is possible to change the programme within 2 minutes after you have switched the dishwasher on. Should it be necessary to change the programme after this period, the programme cycle that has already been begun (e. g. [. . . ] Install the appliance in the following sequence: Check the delivery Install the appliance Connect the waste water Connect the fresh water Connect the power supply
Delivery
Your dishwasher was checked at the factory to ensure that it was in perfect working order. These will disappear after the first rinse cycle.
Installation
The required installation dimensions can be found in the installation instructions. Using the height-adjustable feet, adjust the appliance until it is level. Ensure that the appliance is standing firmly.
Waste water connection
See the installation instructions for the required connection steps. [. . . ]