[. . . ] Régler l'extension de la structure de support de la hotte, la hauteur finale de la hotte dépend de cette régulation; il faut tenir compte qu'une fois l'installation terminée, la distance entre la hotte et le plan de cuisson doit être d'au moins 50 cm pour une cuisson électrique, et de 75 cm pour une cuisson à gaz ou mixte. Electrical connection The electrical tension must correspond to the tension noted on the label placed inside the cooker hood. [. . . ] Insert the safety screw to block the cooker hood to the frame support. Allow the chimney's lower section slide into the housing on top of the cooker hood. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. Maintenance Prior to any maintenance operation ensure that the cooker hood is disconnected from the power supply. Grease filter It must be cleaned once a month, using non-aggressive detergents, manually or in the dish-washer at low temperature and brief cycle. Pull the spring release handle backwards firstly (f1) , then downwards (f2) in order to dismantle the grease filter. The charcoal filter should be replaced every 4 months under normal use. Fit the charcoal filter and fix it to the body of the hood with two supplied screws 4 . 5 Use a one-edged screwdriver or any other appropriate tool to lift and remove the overhead light fixture. Use only halogenous lamps of a maximum of 20W, avoiding contact with hands. If the lights do not work, make sure that the lamps are fitted properly into their housings before you call for technical assistance. Children should not be allowed to tamper with the controls or play with the appliance. [. . . ] Warning: Failure to carry out the basic standards of the cleaning of the cooker hood and replacement of the filters may cause fire risks. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. [. . . ]