[. . . ] Important: Some appliances will start to function at least 6 minutes after the plug has been connected to the power supply outlet and the temperature has been set. During maximum capacity of the freezer, it is advised to remove the drawers and to place the food directly on the shelves for optimal freezing. [. . . ] Drawer, turn the thermostat clock-wise to SUPER position, and the orange light will come on (see figure 1). The SUPER function is automatically disabled from the circuit board after 26 hours. The rating plate states the maximum quantity of foods that can be frozen, (see figure 2). For better air circulation, leave some room in between the foods and avoid blocking the cooling air outlets. A small amount of frost or drops of water on the back of the freezer compartment when the freezer is working is normal. Make sure foods do not touch the back or sides of the freezer compartment. Place the appliance on the floor or at a 45° angle, as it is necessary to work on the bottom of the appliance. Remove the lower plinth by pulling out the 3 protective plugs and by loosening the screws. Take off the bottom right-hand hinge by removing the screws, pin and washers, then remove the lower door. Unscrew the hinge from the fridge door and mount the one supplied on the other side. With this panel type, remove the label and screws, then partially remove the panel. Remove the screws from the top right hinge and invert the position of the pin, then reassemble it on the left-hand side. [. . . ] Remove the screws from the top right hinge and invert the position of the pin, then reassemble it on the left-hand side. With another panel type, break the plastic membrane and screw the hinge on the left-hand side of the panel. [. . . ]