[. . . ] 1) Carefully read the instructions contained in this handbook since they provide important information relative to safety during installation, use and maintenance. 2) Once the appliance has been unpacked make sure that it is undamaged. This appliance should be used only for the purpose for which it was specifically designed, namely for the conservation of foodstuffs. The manufacturer declines all responsibility for any damage that may be caused by unsuitable, incorrect or unreasonable use. [. . . ] This initial operation should only be done when the device is turned on. The 4 green LEDs "D" indicate the temperature inside the freezer. The yellow LED "E" switches on when the super freeze switch "F" is pushed for at least 4 seconds, then the compressor will work continuously. Turning the dial "H" clock-wise, turns the fridge on and the green LED "G" lights up (only if the "A" dial is in a different position from "0"). Failure signal: when the red LED "C" flashes and one of green LEDs "D" is switched on, it means that there is a power failure or some food in the freezer has been at a temperature above 0 degrees for a certain time. To turn the flashing red LED ("C") off push "F" for at least 4 seconds. For optimum results within the freezer we suggest that you set the dial so that the green led "X" lights up, doing this will guarantee optimum food preservation. 13) FOR FROST FREE FRIDGE FREEZER WITH 1 COMPRESSOR Thermostat dial "A" controls the temperature in the freezer, when the dial is in the "0" position the fridge and freezer are both off. Turning dial "A" clock-wise turns the freezer on, with the green LED "B" and the red LED "C" switching on. when the freezer reaches the set temperature the red LED will switch off. The yellow LED "E" switches on when dial "A" is turned to the "SUPER" position, then the compressor will work continuously. Turning the dial "H" clock-wise, turns the fridge on and the green LED "G" switches on (only if the "A" dial is in a different position from "0"). 13) When the red LED "C" is on or lit up, the temperature inside the fridge or freezer is not cold enough. Reasons for failure: - appliance has just been switched on - door left opened or ajar - fresh food for freezing just placed inside the freezer. CAUTION: There is no correlation between the numbers shown on the thermostat dial (A) and the temperatures displayed on the 4 green lights (D). By turning the thermostat knob clockwise, the appliance operates and green light "B" lights up. cONSERVATION Some models feature a storage area above the top refrigerated shelf. This area must be used as a two star compartment as shown on the appliance. the maximum performance of conservation is obtained by removing all the crispes but lower one. The symbol shows that frozen products can be stored for a long time and that p fresh foods can be frozen. Conservation time are closely connected with maintaining the correct temperature, thus any changes will affect the length of time it can be conserved. In the case of a power cut do not, under any circumstances, open the door or the lid. [. . . ] 7c ­ inside upper portion of the top door), remove caps F-G, pivot D and the right upper hinge, taking away the screw. Take the left upper hinge (H) from plastic bag and fix it with the screw you have removed. After transferring the hinge to the left hand side, the plastic insert (L) which covers this mechanism needs to be altered, the membrane of cap G needs to be broken so that its fits back into place. 9) Replace the doors working in a reverse fashion (6-5-4-3-2); remembering to refit the spacing washers between door and hinge. [. . . ]