[. . . ] Read this manual carefully so that you know when such situations can arise. Ensure that all operators of this machine are fully trained on how it works. Report any problems or damage to the machine immediately to the supplier or a Nilfisk approved supplier for this product. Do not operate the machine until the problem or damage has been resolved. · · Getting the Best Results . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . · · Operate the machine in accordance with the instruction manual Maintain the machine in accordance with instruction manual · · Use only parts supplied by Nilfisk ALTO approved distributors Use only detergents and cleaning products in the solution tank which have been approved by Nilfisk ALTO Keep this manual in a safe place for future reference and ordering of spare parts 7 English Installation · · Lift the machine out of the box. [. . . ] · This will switch on the boiler elements and will enable you to use the handle controls on the hose once connected. Fill the cold water tank (Number 1 Diagram A) with clean cold water only. Anything other than clean cold water used in the water tank will void the manufacturers warranty. Fill the detergent tank (Number 2 Diagram A) with Nilfisk ALTO approved detergent. Unapproved detergent may be harmful or dangerous to the machine or the operator using the machine. This may cause irrepairable damage to seals and will void the manufacturers warranty. Connect the Vacuum Hose to the front of the machine (Number 6 Diagram A) ensuring it locks into position. To release the vacuum hose from the socket slide the red button upwards at the same time as pulling the hose out. Do not attempt this task yourself, contact a Nilfisk ALTO approved supplier for replacement. Connect the Steam Hose to the front of the machine (Number 7 Diagram A) ensuring it is pushed in all the way and the pin on the flap locks into the hole on the hose. If the cable becomes damaged at anytime the complete cable must be replaced by a Nilfisk approved distributor. When the Steam Ready LED (Number 14 Diagram B) illuminates the machine is ready to be used. 9 English Operating Procedure cont. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11. · The red trigger on the hose handle will release steam when pressed. · The red button on the side of the handle will lock the steam trigger in the off position. · Pressing the left hand switch on top of the handle will activate the vacuum. · Pressing the right hand momentary switch located on the top of the handle will activate the detergent pump. The steam output can be adjusted by the steam control knob (Number 3 Diagram A) 13. When changing accessories during use please note these will be hot. During Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Cold Water Tank Empty(Number 1 Diagram A) 1. Refill the cold water tank when the refill cold water LED (Number 15 Diagram B) is illuminated. A buzzer will sound and the steam will no longer come out of the nozzle when the steam switch on the handle is pressed. [. . . ] Call for service Wait for the "Ready to steam " light to illuminate Hold the steam switch on for approximately one minute, ever if just water is coming out. This will result in the heater coming back on Call for service Change and re grease "O" Rings. To avoid this happening ensure "o" rings are grease before every use. To avoid this happening ensure "o" rings are grease before every use. [. . . ]