[. . . ] General note concerning NiMH batteries: The capacity of the battery is reduced when the temperature falls below 10°C. Long-term storage at temperatures higher than +40°C may have negative effects on the capacity of the battery. [. . . ] CHARACTERISTICS After inserting the battery into the reception of the charger the battery will automatically be charged (red lamp is illuminated continuously, green lamp is flashing) When a hot or cold battery pack is inserted into the charger (flashing red lamp), charging will begin automatically once the battery reaches the correct charging temperature (-5°C. Charging time varies depending on the battery temperature, charge needed and the type of battery pack being charged. As soon as charging is completed, the charger switches over to "trickle" charge to maintain the full capacity (green control lamp is illuminated continuously, red lamp off) If both LEDs flash at the same time, either the battery has not been completely mounted or there is a fault in the battery or the charger. For safety reasons you must stop using the charger and battery immediately and have them inspected by an AEG Customer Service Centre. EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents: EN 60335, EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3, EN 50 366, in accordance with the regulations 2006/95/EC, 89/336/EEC 900 g SAFETY INSTRUCTIONS Please pay attention to the safety instructions in the attached leaflet!Do not dispose of used battery packs in the household refuse or by burning them. SPECIFIED CONDITIONS OF USE The quick charger can charge AEG System GBS batteries from 9. It is also possible to connect to sockets without an earthing contact as the design conforms to safety class II. Manager Product Development MAINTENANCE If the supply cord of this appliance is damaged, it must only be replaced by a repair shop appointed by the manufacturer, because special purpose tools are required Use only AEG accessories and AEG spare parts. Should components need to be replaced which have not been described, please contact one of our AEG service agents (see our list of guarantee/service addresses). As well as the machine type printed on the label and order the drawing at your local service agents or directly at: AEG Elektrowerkzeuge, Max-Eyth-Straße 10, D-71364 Winnenden, Germany. SYMBOLS Please read the instructions carefully before starting the machine. [. . . ] SYMBOLS Please read the instructions carefully before starting the machine. Do not dispose of electric tools together with household waste material! [. . . ]