[. . . ] Please read and save these instruction You demand the best and buy quality - quality provided by Atlas Copco. Working effectively and without endangering your health is only possible if this instruction for use is read carefully before first using the tool. [. . . ] Smoothing metals with the backing pad and vulcanised fibre-grinding disks) high contamination can build up inside the angle grinder. In such cases we recommend: the use of a stationary dust extraction device; cleaning the machine more regularly; and/or the use of an ELCB safety switch (earth leakage circuit breaker). Measured sound value Typically the A-weighted noise levels of the tool are: Sound pressure level = 85 dB (A). This angle grinder can be used for separating and grinding many different materials, e. Connect only to a single-phase AC current supply and only to the mains voltage specified on the rating plate. When fitting the plug, make sure that the brown (live) wire of this appliance is connected to the plug terminal marked L or coloured red, and the blue (neutral) wire of this appliance is connected to the plug terminal marked N or coloured black. Under no circumstances must the wires of this appliance be connected to the earth terminal of the plug marked either E, with the earth symbol, or coloured green or green/ yellow. The electronic smooth start will prolong the life of both the motor and the gears. Electronic speed adjustment ensures constant speed even when the load on the motor varies. In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. The speed of rotation is adjusted electronically when the load increases. Under the effect of extreme electromagnetic interferences from the outside, temporary variations in the speed of rotation could arise in particular cases. [. . . ] Endast till enfas-växelström och endast till den nätspänning som finns angiven på effektskylten. We declare under our sole responsibility that this product is in conformity with the following standards or standardization documents: EN 50 144, EN 55 014, EN 55 014-2, EN 60 555, HD 400 according to the provisions of the regulations 73/23/EEC, 89/336/EEC, 89/392/EEC. [. . . ]