[. . . ] GB Your standards are high and you have opted for quality from Atlas Copco. Make good use of your new electric power tool, we have built it with great care, but first read the instruction booklet. [. . . ] 4 Before you use this tool Always disconnect the plug from the socket before carrying out any work on the machine. Place guard on the gear neck (LEERER MERKER) of the machine and then tighten screw (LEERER MERKER). The position of the guard can be adjusted to the requirements of the work process. When making this adjustment, take care to ensure that the grinding disc can rotate freely. When grinding do not apply pressure to the workpiece by bearing down on the machine but move the grinding disc backward and forward over the working surface. Grinding For best results with grinding discs, keep the disc at an angle at least 30o to the working surface. Overloading the machine during grinding operations will harm the machine, reduce disc life and produce inferior results. Secure working spindle (LEERER MERKER) by pressing spindle lock (LEERER MERKER). Mount back flange (LEERER MERKER), grinding disc (LEERER MERKER) and flange nut (LEERER MERKER) according to the illustration and tighten flange nut with a pin­type spanner. When the thickness of the disc is less than 5, 5 mm use the flange nut with the flat side against the grinding disc. [. . . ] Endast till enfas-växelström och endast till den nätspänning som finns angiven på effektskylten. We declare under our sole responsibility that this product is in conformity with the following standards or standardized documents. [. . . ]