[. . . ] The Sagem Fax ATA 101S is a voice over IP gateway allowing you to connect analog terminals (fax machine, telephone, etc. ) to a voice over IP infrastructure (IP operator , IPPBX or VoIP gateway). Through the Sagem Fax ATA 101S, you can continue to use your analog telecommunications peripherals via your voice over IP telephone architecture. The bandwidth to be reserved depends on the codec you use: · 1 power supply unit CAUTION! [. . . ] Dynamic Host Configuration Protocole (DHCP) Network protocol the role of which is to automatically set up the TCP/IP settings of computer hardware by automatically assigning it with an IP address. 711 Audio coding standard, more specifically used in human voice coding telephony. Using this standard is equivalent to coding the voice signal at 64 kbps. 711 format is suitable for fax transfers when the T38 format is not available. 729 Audio coding standard, more specifically used in human voice coding telephony. Using this standard is equivalent to coding the voice signal at 8 kbps. It is responsible for authenticating and locating multiple participants, and also for negotiating the types of media that can be used by participants. This protocol is principally used to remotely load firmware and setup files in computer hardware. Read these safety notes carefully before using this product to make sure you operate the equipment safely. Warning: This warning alerts users to areas of the product where there is the possibility of personal injury. Your Sagem Communications product and recommended supplies have been designed and tested to meet strict safety requirements. These include safety agency approval, and compliance to established environmental standards. Please read the following instructions carefully before operating the product and refer to them as needed to ensure the continued safe operation of your product. The safety and environment testing and performance of this product have been verified using Sagem Communications materials only. Warning: Any unauthorized alteration, which may include the addition of new functions or connection of external devices, may impact the product warranty. Warning Markings: All warning instructions marked on or supplied with the product should be followed. Do not remove the type plate from your device; this would voice the warranty. Protect the device against direct sunlight, heat, large temperature fluctuations and moisture. do not place the device in the vicinity of heaters or air conditioners. In the event that the device becomes too hot, or if you see smoke coming from the device, you must immediately pull the power cable out of the power socket. have your device examined by trained professionals at a technical service location. To prevent the spread of fire, open flames should be kept away from the device. [. . . ] This user manual was printed on recycled paper bleached without chlorine. The cardboard packaging used and the packaging inserts of paper and cardboard can be disposed of as waste paper. The plastic foil may be submitted for recycling or disposed of with waste not intended for recycling, depending on the requirements in your country. The references mentioned in this manual are trademarks of the respective companies. [. . . ]