[. . . ] Operating instructions
Optima Series G 1470 G 2470
To prevent accidents and machine damage read these instructions before installation or use.
UV
M. -Nr. 59
3
IMPORTANT SAFETY INSTRUCTIONS WARNING
When using your dishwasher, follow basic precautions, including the following: Read all instructions before installation or use of the dishwasher to prevent injury and machine damage.
Electrical Safety
Before installation, make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. Before installation or service, disconnect the power supply to the work area by unplugging the unit, "tripping" the circuit breaker or removing the fuse. Do not use an extension cord to connect this appliance to electricity. [. . . ] The running time for the same program may vary depending on the intake water temperature, load size and soiling. When a program is selected for the first time, a time is shown which equals an average program running time with cold water. The time values in the program guide correspond to the program running times with standard loads and temperatures. Each time a program is run, the electronic adjusts the program running time according to the intake water temperature and the load size.
At the end of a program
At the end of a program the optical function light flashes slowly with the door closed. The optical function light goes out one hour after the end of a program. The dishwasher continues to use electricity until turned off with the "o" button. vacationing, turn off the water supply.
Glasscare indicator
The green Glasscare indicator lights during the China & Crystal program. This indicates that a program has been selected which washes glasses especially gently.
31
Use
Interrupting a program
A program is interrupted as soon as the door is opened. If the door is closed, the program will continue from where it was interrupted.
Changing a program
If the detergent flap is already open, do not change the program. If a program has already started and you wish to change it: ^ Open the door. Close the door firmly until it clicks into place.
32
Additional options
Detergent settings
To achieve the best results, set the detergent used to your dishwasher. The "Detergent" button allows you to select the function "2 in 1" or "Gel". The program cycle sequence will be adjusted for the selected detergent. "2 in 1" The function "2 in 1" adjusts the program cycle to the use of "2 in 1" detergent products (detergent with rinse aid). The rinse aid dosage and the rinse aid refill indicator will be deactivated. "Gel" The function "Gel" adjusts the program cycle to the use of liquid "Gel" detergent products. The cleaning and drying performance of these detergent products varies.
^ Open the door. ^ Press the "Detergent" button until the indicator of the desired detergent "2 in 1" or "Gel" lights. If none of the indicators are lit, the dishwasher is set to powder detergent. The set function will be active for all programs until the setting is changed. ^ A program can be started or the dishwasher can be turned off "o".
33
Additional options
Delay start
The starting time of a program can be delayed. With a delay start time between 30 minutes and 9 hours 30 minutes the delay is set in 30 minute steps. [. . . ] Before discarding an old appliance, unplug it from the outlet, cut off its power cord and remove any doors to prevent hazards.
56
Electrical connection , Installation, repairs and other work by unqualified persons could be dangerous. The manufacturer cannot be held responsible for unauthorized work.
Check that the voltage, frequency and fuse rating shown on the data plate match the household mains supply. A damaged power cord must only be replaced with a genuine Miele cord by a Miele service technician. In the event of a malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for the electrical current. [. . . ]